MINIの取扱説明書・マニュアル [全176ページ 2.84MB]
ownersmanual2011countryman.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2011countryman.pdf - 2.84MB
- キャッシュ
9933view
176page / 2.84MB
Replacing components1363Holder for the sealant bottle4Compressor5Plug and cable for the socket in the vehicle interior, page826Connection hose to connect the compressor and sealant bottle or the compressor and wheel7On/off switch8Pressure gauge for indi cating the tire infla-tion pressure9Release button for reducing the tire inflation pressureConnector, cable and connection hose are stored in the compressor housing.Using the Mobility SystemTo repair a tire puncture with the Mobility Sys-tem, proceed as follows:>Filling the tire with sealant>Distributing the sealant>Correct the tire inflation pressureFilling the tire with sealantProceed in the specified order; otherwise, sealant may emerge under high pres-sure.<1.Shake the sealant bottle.2.Pull the connecting hose 6 completely out of the compressor housing and screw it onto the connector of the sealant bottle. Make sure that the hose is not kinked.3.Insert the sealant bo ttle on the compressor housing in an upright position.4.Unscrew the dust cap fr om the valve of the defective wheel and screw the filling hose 2 of the sealant bottle onto the valve.5.Ensure that the compre ssor is switched off.6.Insert the plug 5 into the lighter socket/power socket in the vehicle interior, page82.7.With the engine running: Switch on the compressor and let it run for approx. 3 to 8 minutes to fill the tire with sealant and achieve a tire inflation pressure of approx. 26 psi/180 kPa.When filling with the sealant, the infla-tion pressure can briefly rise to approx. 73 psi/500 kPa. Do not switch off the compressor during this phase. <Do not run the compressor for longer than 10 minutes; otherwise, the device will overheat and possibly be dam-aged.<8.Switch off the compressor.If an air pressure of 26 psi/180 kPa is not reached:1.Unscrew the filling hose 2 from the wheel and drive the vehicle forward and backward approx. 33 ft/10 m to distribute the liquid sealant in the tire evenly.2.Inflate the tire again with the compressor.If an inflation pressure of 26 psi/180 kPa still cannot be reache d, the tire is too heavily damaged. Please contact the nearest MINI dealer.<
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
33789 view
12137 view
43474 view
3622 view
28967 view
もっと見る