MINIの取扱説明書・マニュアル [全176ページ 2.84MB]
ownersmanual2011countryman.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2011countryman.pdf - 2.84MB
- キャッシュ
9933view
176page / 2.84MB
137AT A GLANCE Reference Mobility Controls Driving tips CommunicationsStowing Mobility System1.Unscrew filler hose 2 of the sealant bottle from the wheel.2.Unscrew connecting hose of the compressor6 from the sealant bottle.3.Connect the filler hose 2 of the sealant bot-tle to the unoccupied connection on the sealant bottle.This prevents the rest of the sealant from escaping from the bottle.4.Wrap the empty sealan t bottle in suitable material to avoid dir tying the cargo area.5.Stow Mobility System back in the vehicle.Distributing the sealantImmediately drive appr ox. 3.1 miles/5 km to evenly distribute the sealant.Do not exceed speeds of 50 mph/80 km/h.If possible, do not drop below 10 mph/ 20 km/h.<Correct the tire inflation pressure1.After driving for appr ox. 3.1 miles/5 km or ten minutes, stop at a suitable location.2.Screw the connection hose 6 of the com-pressor directly onto the tire valve.3.Insert the plug 5 into the power socket in the vehicle interior.4.Correct inflation pressu re to 26 psi/180 kPa. With the engine running:>To increase the inflatio n pressure: switch on the compressor. To check the current infla-tion pressure, switch off the compressor.Do not run the comp ressor for longer than 10 minutes; otherwise, the device will overheat and possibly be dam-aged.<>To decrease the inflat ion pressure: press the release button9.If the tire cannot maintain the inflation pressure, drive the vehicle again, refer to Distributing the sealan t. Then repeat steps 1to4.If an inflation pressure of 26 psi/180 kPa still cannot be reached, the tire is too heavily dam-aged. Contact the nearest MINI dealer. <Driving onDo not exceed the permitted maximum speed of 50 mph/80 km/h; doing so may result in an accident. <Replace the defective tire as soon as possible and have the new wheel/tire assembly bal-anced.Have the Mobility System refilled.Changing wheelsThe pouch with the wheel changing kit * is stored under the flat load floor. It includes:>Vehicle jack>Reversible ratchet>Wheel stud wrench>Extractor hook for wheel center cover>ChockPreparing for a wheel changeObserve the safety precautions regarding flat tires on page135.<Additional safety me asures when chang-ing tires: Only change the tire when parked on a surface that is level, firm and not slippery.The vehicle or the jack could slip sideways on soft or slippery support surfaces, such as snow, ice, flagstones, etc. Do not use a wooden block or similar object as a support base for the jack , as this would prevent it from extending to its full support height and reduce its load-carrying capacity. Do not lie under the vehicle or start the engine when the vehicle is supported by the jack; other-wise, there is a risk of fatal injury. <
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
33789 view
12137 view
43474 view
3622 view
28967 view
もっと見る