MINIの取扱説明書・マニュアル [全283ページ 9.38MB]
ownersmanual2012couperoadsterconvertible.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2012couperoadsterconvertible.pdf - 9.38MB
- キャッシュ
8090view
283page / 9.38MB
MOBILITY Replacing components238Using the Mobility KitTo repair a tire puncture with the Mobility Kit, proceed as follows:>Fill the tire with sealant.>Distribute the sealant.>Correct the tire inflation pressure.Filling the tire with sealantProceed in the specified order; otherwise, sealant may emerge under high pressure.<1.Shake the sealant bottle.2.Pull the connecting hose 6 completely out of the compressor housing and screw it onto the connector of the sealant bottle. Make sure that the hose is not kinked.3.Insert the sealant bo ttle on the compressor housing in an upright position.4.Unscrew the dust cap from the valve of the defective wheel and screw the filling hose 2 of the sealant bottle onto the valve.5.Ensure that the compressor is switched off.6.Insert the plug5 into the lighter socket/power socket in the vehicle interior, page110.7.With the engine running: Switch on the compressor and let run for about 3 to 8 minutes in order to add the sealant and to achieve an inflation pressure of about 1.8 bar/26 psi.When adding the sealant, the filling pressure can temporarily increase up to about 5 bar/73 psi. Do not switch off the compressor during this phase. <Do not run the compressor for longer than 10 minutes; otherwise, the device will overheat and possibly be damaged.<8.Switch off the compressor.If an inflation pressure of 1.8 bar/26 psi is not reached:1.Unscrew the filling hose 2 from the wheel and drive the vehicle forward and backward approx. 33 ft/10 m to distribute the liquid sealant in the tire evenly.2.Inflate the tire again with the compressor.If an inflation pressure of 1.8 bar/26 psi is not reached, then the tire is too badly damaged. Please contact the nearest MINI dealer.<Stowing Mobility Kit1.Unscrew filler hose 2 of the sealant bottle from the wheel.2.Unscrew connecting hose of the compressor6 from the sealant bottle.3.Connect the filler hose 2 of the sealant bottle to the unoccupied connection on the sealant bottle.This prevents the rest of the sealant from escaping from the bottle.4.Wrap the empty sealant bottle in suitable material to avoid dirtying the cargo area.5.Stow Mobility Kit back in the vehicle.Distributing the sealantImmediately drive appr ox. 3.1 miles/5 km so that the sealant evenly distributes itself.Do not exceed speeds of 50 mph/ 80 km/h.If possible, do not drop below 10 mph/ 20 km/h.<
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
32624 view
11784 view
42505 view
3450 view
28391 view
もっと見る