MINIの取扱説明書・マニュアル [全283ページ 9.38MB]
ownersmanual2012couperoadsterconvertible.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2012couperoadsterconvertible.pdf - 9.38MB
- キャッシュ
8883view
283page / 9.38MB
Replacing components MOBILITY 239Adjusting the tire pressure1.After driving approx. 3.1 miles/5 km or 10 minutes, stop at a suitable location.2.Screw the connection hose 6 of the compressor directly onto the tire valve.3.Insert the plug5 into the power socket in the vehicle interior.4.Adjust tire pressure to 1.8 bar/26 psi. With the engine running:>To increase the inflatio n pressure: switch on the compressor. To check the current infla-tion pressure, switch off the compressor.Do not run the compressor for longer than 10 minutes; otherwise, the device will overheat and possibly be damaged.<>To decrease the inflation pressure: press the release button9.If the tire cannot ma intain the inflation pressure, drive the vehicle again, refer to Distributing the sealan t. Then repeat steps 1to4.If an inflation pressure of 1.8 bar/26 psi still cannot be reached, then the tire is too heavily damaged. Contact your nearest MINI dealer. <Driving onDo not exceed the permitted maximum speed of 50 mph/80 km/h; doing so may result in an accident. <Replace the defective tire as soon as possible and have the new wheel/tire assembly balanced.Have the Mobility Kit refilled.Changing wheelsRun-flat tiresTire change for run-flat tires:>Prepare for tire change, page 240>Jack up vehicle, page 241>Tighten lug bolts, page 241Space-saver spare tireTire change with space-saver spare tire:>Remove the space-saver spare tire, page239>Prepare for tire change, page 240>Jack up vehicle, page 241>Mount space-saver spare tire, page 241>Tighten lug bolts, page 241>Drive with space-saver spare tire, page 240Removing the space-saver spare tireThe screw connection of the space-saver spare tire is under the floor mat in the cargo area, on the base of the storage compartment for the tire change set.1.Unscrew the screw connection with the special wrench.2.Take out the cover panel.3.Screw the lifting handle from the toolkit onto the thread.4.Raise the lifting handle slightly.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
35101 view
12445 view
44855 view
3715 view
29279 view
もっと見る