X3の取扱説明書・マニュアル [全144ページ 4.54MB]
123812.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123812.pdf - 4.54MB
- キャッシュ
7959view
144page / 4.54MB
Driving42Atypically rapid flashing of the indicator lamp indicates that a turn signal bulb has gone out. <Signaling brieflyPress lever to resistance point and hold for as long as you wish to signal.Touch signalingPress lever to resistance point. The signal flashes three times.If you wish, you can have this function deactivated. <Washer/wiper system/rainsensor*0Wipers retracted1Intermittent or rain sensor operation2Normal wiper speed3Fast wipe4Brief wipe5Select interval time or set sensitivity of rain sensorFold-out positionThe right wiper is part ially concealed by the hood. To move the wipers into a vertical position:1. Switch on wipers in lever position 1 .2. When the wipers are approximately vertical, move the ignition key to position 0.For changing the wiper blades, refer to page111 .Fold the wipers back down onto the wind-shield before you turn the ignition key to position 1 or 2 again. If you do not, they could be damaged. <Intermittent modeNot provided in vehicles with rain sensor.You can set the wipe interval to four stages with the serrated dial 5 . In addition, the wipe interval is varied automati-cally depending on road speed.Rain sensor*The rain sensor automa tically controls wiper operation as a function of the rain intensity. The sensor is mounted on the windshield, directly in front of the interior rearview mirror.Deactivate the rain sensor when passing through an automatic car wash. Failure to do so could result in damage caused by undes-ired wiper activation. <ActivatingWith the ignition key in position 1 or higher, move the lever to position1 . The wipers travel once across the windshield, regardless of the weather conditions.You can leave the lever permanently in posi-tion1 and then only need to activate the rain sensor whenever the ignition key is in position 1 or higher. To do so:>Briefly turn the serrated dial 5 or>Clean the windshield 1 , refer to page 43Adjusting sensitivityTurn the serrated dial 5 .DeactivatingSwitch lever to position 0 .Normal wiper speedThe system switches auto matically to intermit-tent mode when the vehicl e is stationary, not on vehicles with rain sensor.
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
54215 view
26428 view
21148 view
21291 view
23338 view
もっと見る