1. 取扱説明書・マニュアル >
2. BMW >
3. 自動車 >
4. X3 の使い方、故障・トラブル対処法 >
5. X3 の取扱説明書・マニュアル

X3の取扱説明書・マニュアル [全144ページ 4.54MB]

Lamps60Automatic headlamp control*In switch position3 , the low beams are switched on or off automatically, for example in tunnels, at dawn and dusk, and in the event of precipitation. The Adaptive Head Light* is acti-vated.When you enter a tunnel with bright ceiling lighting, this can delay the switching on of your low beams.The headlamps can also come on when the sun is low on the horizon in a blue sky.The low beams remain switched on regardless of the ambient light when you switch on the front fog lamps*.When the daytime driving lamps are activated, refer to page 59 , the low beam headlamps are always switched on when the switch is in posi-tion3 and the ignition is switched on. <If so desired, the light switch can remain in position 3 . The exterior lamps are automatically switched off after the ignition is switched off.Automatic headlamp control cannot serve as a substitute for the driver's judg-ment in determining when the vehicle lamps should be switched on. For example, the sys-tem cannot detect fog or hazy weather. To avoid safety risks, you sh ould always switch on the low beams manually under these condi-tions. <You can have the sensitivity of the head-lamp control adjusted. <Adaptive Head Light*The conceptAdaptive Head Light is a variable headlamp control system that en ables better illumination of the road surface. Depending on the steering angle and other parameters, the light from the headlamp follows the course of the road.In tight curves, e.g. serpentines, or when mak-ing turns, up to a speed of approx. 43 mph/70 km/h, a turning lamp is switched on and illu-minates the inside of the curve.Activating Adaptive Head LightWith the ignition on, turn the light switch to the Automatic headlamp cont rol position, refer to page59 .The turning lamp is swit ched on automatically depending on the steering angle or the turn sig-nal position.In order not to blind oncoming traffic, the Adap-tive Head Light points toward the passenger side when the vehicle is stopped. When driving in reverse, only the turn ing lamp is active and lights up the region on the outside of the curve.MalfunctionThe LED next to the symbol for automatic head-lamp control flashes. Adaptive Head Light is malfunctioning or has fa iled. Have the system checked as soon as possible.High beams/roadsideparkinglamps1High beams2Headlamp flasher3Roadside parking lampsRoadside parking lamps, left or right*You also have the option of lighting up just one side of your vehicle when parking. When doing so, be sure to comply wi th national regulations.After switching off the engine, press the lever up or down past the resistance point, arrow 3 .The roadside parking lamps drain the bat-tery. For this reason, avoid using them for extended periods; otherwise, it may no longer be possible to start the engine. <

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.