X3の取扱説明書・マニュアル [全144ページ 4.54MB]
123812.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123812.pdf - 4.54MB
- キャッシュ
7959view
144page / 4.54MB
ReferenceAt a glanceControlsDriving tipsMobility 69Practical interior accessoriesIntegrated universal remote control*The conceptThe integrated universa l remote control can replace as many as three hand-held transmit-ters for various radio-controlled accessories, such as garages, exterior gates, or lighting sys-tems. The integrated universal remote control recognizes and learns the transmitted signal of each of the original hand-held transmitters.The signal of an original hand-held transmitter can be programmed on one of the three mem-ory buttons 1 . Then, the programmed memory button 1 can operate the device whenever the ignition is switched on. The LED2 indicates transmission of the signal.Should you sell your vehicl e one day, be sure to delete the stored progra ms beforehand for your security, refer to page70 .To prevent possible damage or injury, before programming or using the inte-grated universal remote control, always inspect the immediate area to make certain that no peo-ple, animals or objects are within the travel range of the device. Also, comply with the safety pre-cautions of the original hand-held transmitter. <Checking compatibilityIf you see this symbol on the packaging or in the manual supplied with the origi-nal hand-held transmitter, then it is safe to assume that the radi o-controlled device is compatible with the integrated universal remote control.If you have additional questions, please ask at your BMW Sports Activity Vehicle Center or call: 1-800-355-3515.You can find also information on the Internet at:www.bmwusa.com or www.homelink.com. HomeLink is a registered trademark of Johnson Controls, Inc. <Programming1Memory buttons2LEDFixed-code hand-held transmitters1. Turn the ignition key to position 2.2. For initial use: press the left and right mem-ory button 1 for approx. 20 seconds until the LED 2 flashes rapidly. All stored pro-grams are deleted.3. Hold the original hand-held transmitter at a distance of approx. 4 in/10 cm to 12 in/30 cm from the memory buttons 1 .The required distance between the hand-held transmitter and memory buttons 1 depends on the relevant system of the original hand-held transmitter used.<4. Simultaneously press the transmit button on the original hand-held transmitter and the desired memory button 1 of the inte-grated universal remote control. Initially, the LED 2 flashes slowly. Re lease both buttons as soon as the LED 2 flashes rapidly. If the LED 2 does not flash rapidly after approx. 15 seconds, then change the distance and repeat the step.5. To program other original hand-held trans-mitters, repeat steps 3 and 4.The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.You can use the system when the engine is run-ning or when the ignition is switched on.
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
54215 view
26428 view
21148 view
21291 view
23338 view
もっと見る