X3の取扱説明書・マニュアル [全211ページ 8.62MB]
123815.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123815.pdf - 8.62MB
- キャッシュ
31936view
211page / 8.62MB
DisplaySignal tonesWhen approaching an object, an intermittenttone is sounded that indicates the position of theobject. For example, if an object is detected tothe left rear of the vehicle, a signal tone soundsfrom the left rear speaker.The shorter the distance to the object becomes,the shorter the intervals.If the distance to a detected object is less thanapprox. 12 in/30 cm, a continuous tone issounded.If objects are located both in front of and behindthe vehicle, an alternating continuous signal issounded.The intermittent tone is interrupted after approx.3 seconds:▷If the vehicle stops in front of an object thatis detected by only one of the corner sen‐sors.▷If moving parallel to a wall.The signal tone is switched off:▷When the vehicle moves away from an ob‐ject by more than approx. 4 in/10 cm.▷When transmission position P is engaged.VolumeThe volume of the PDC signal can be adjusted,refer to user's manual for Navigation, Entertain‐ment and Communication.The setting is stored for the remote control cur‐rently in use.Visual warningThe approach of the vehicle to an object can beshown on the Control Display. Objects that arefarther away are displayed on the Control Dis‐play before a signal tone sounds.A display appears as soon as Park DistanceControl (PDC) is activated.The range of the sensors is represented in col‐ors: red, green and yellow.If the backup camera image was selected last, itagain appears on the display. To switch to PDC:1. "Rear view camera" Select the symbolon the Control Display.2. Press the controller.The setting is stored for the remote control cur‐rently in use.System limitsLimits of ultrasonic measurementThe detection of objects can reach the physicallimits of ultrasonic measurement, e.g.:▷With tow bars and trailer hitches.▷With thin or wedge-shaped objects.▷With low objects.▷With objects with corners and sharp edges.Low objects already displayed, e.g., curbs, canmove into the blind area of the sensors before orafter a continuous tone sounds.High, protruding objects such as ledges may notbe detected.False warningsPDC may issue a warning under the followingconditions even though there is no obstaclewithin the detection range:▷In heavy rain.▷When sensors are very dirty or covered inice.▷When sensors are covered in snow.▷On rough road surfaces.▷In large buildings with right angles andsmooth walls, e.g., in underground garages.▷In heavy exhaust.▷Due to other ultrasound sources, e.g.,sweeping machines, high pressure steamcleaners or neon lights.Seite 113Driving comfort Controls113Online Edition for Part no. 01 40 2 903 813 - 07 12 490
参考になったと評価
8人が参考になったと評価しています。
その他の取扱説明書
54946 view
26681 view
21243 view
21397 view
23409 view
もっと見る