X3の取扱説明書・マニュアル [全211ページ 8.62MB]
123815.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123815.pdf - 8.62MB
- キャッシュ
32682view
211page / 8.62MB
CareVehicle equipmentAll standard, country-specific and optionalequipment that is offered in the model series isdescribed in this chapter. Therefore, equipmentis also described that is not available in a vehicle,e. g., because of the selected optional equip‐ment or country variant. This also applies forsafety-related functions and systems.Car washesNotesSteam jets or high-pressure washersWhen using steam jets or high-pressurewashers, hold them a sufficient distance awayand use a maximum temperature of140 ℉/60 ℃.Ensure that a distance of at least 31.5 in‐ches/50 cm is maintained at all times. Holdingthem too close or using excessively high pres‐sures or temperatures can cause damage orpreliminary damage that may then lead to long-term damage.Follow the operating instructions for the high-pressure washer.◀Cleaning sensors/cameras with high-pressure washersWhen using high-pressure washers, do notspray the exterior sensors and cameras, e.g.,Park Distance Control, for extended periods oftime and only from a distance of at least12 in/30 cm.◀Wash your vehicle frequently, particularly in win‐ter.Intense soiling and road salt can damage the ve‐hicle.Automatic car washesNotesNote the following:▷Give preference to cloth car washes or thosethat use soft brushes in order to avoid paintdamage.▷Make sure that the wheels and tires are notdamaged by the transport mechanisms.▷Fold in the exterior mirrors; otherwise, theymay be damaged, depending on the width ofthe vehicle.▷Deactivate the rain sensor, refer to page 67,to avoid unintentional wiper activation.▷In some cases, an unintentional alarm can betriggered by the interior motion sensor of thealarm system. Follow the instructions onavoiding an unintentional alarm, refer topage 42.Guide rails in car washesAvoid car washes with guide rails higherthan 4 in/10 cm; otherwise, the vehicle bodycould be damaged.◀Before driving into a car washIn order to ensure that the vehicle can roll in a carwash, take the following steps:Automatic transmission:1. Release parking brake, refer to page 63, anddeactivate Automatic Hold, refer topage 64.2.Drive into the car wash.3. Depress the brake pedal as needed.4. Engage transmission position N.5. Switch the engine off. In this way, the igni‐tion remains switched on, and a Check-Con‐trol message is displayed.Seite 183Care Mobility183Online Edition for Part no. 01 40 2 903 813 - 07 12 490
参考になったと評価
8人が参考になったと評価しています。
その他の取扱説明書
55965 view
27175 view
21580 view
21686 view
23747 view
もっと見る