X3の取扱説明書・マニュアル [全211ページ 8.62MB]
123815.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123815.pdf - 8.62MB
- キャッシュ
31527view
211page / 8.62MB
sure that the indicator lamp for the front pas‐senger airbags lights up. This indicates that thechild seat has been detected and the front pas‐senger airbags are not activated.Strength of the driver's and frontpassenger airbagThe strength with which the driver's and frontpassenger airbags are triggered depends on theposition of the driver's and front passengerseats.To maintain the accuracy of this function overthe long-term, calibrate the front seats when acorresponding message appears on the ControlDisplay.Calibrating the front seatsA corresponding message appears on the Con‐trol Display.1. Move the respective seat forward all theway.2. Move the respective seat forward again. Itmoves forward briefly.3. Readjust the seat to the desired position.The calibration procedure is completed whenthe message on the Control Display disappears.If the message continues to be displayed, repeatthe calibration.If the message does not disappear after a repeatcalibration, have the system checked as soon aspossible.Unobstructed area of movementEnsure that the area of movement of theseats is unobstructed to avoid personal injury ordamage to objects.◀Tire Pressure Monitor TPMThe conceptThe tire inflation pressure is measured in thefour mounted tires. The system notifies you ifthere is a significant loss of pressure in one ormore tires.Functional requirementsThe system must have been reset when the in‐flation pressure was correct; otherwise, reliablesignaling of a flat tire is not ensured. Always usewheels with TPM electronics to ensure that thesystem will operate properly. Reset the systemafter each correction of the tire inflation pres‐sure and after every tire or wheel change.System limitsSudden tire damageSudden serious tire damage caused byexternal influences cannot be indicated in ad‐vance.◀The system does not operate correctly if it hasnot been reset. For example, a flat tire may beindicated despite correct tire inflation pres‐sures.The system is inactive and cannot indicate a flattire:▷For a mounted wheel without TPM electron‐ics.▷When the TPM is disturbed by other sys‐tems or devices with the same radio fre‐quency.Status displayThe current status of the Tire Pressure MonitorTPM can be displayed on the Control Display,e.g., whether or not the TPM is active.1. "Vehicle Info"2."Vehicle status"3. "Tire Pressure Monitor - TPM"The status is displayed.Status displayThe tire and system status is indicated by thecolor of the tires.Seite 94Controls Safety94Online Edition for Part no. 01 40 2 903 813 - 07 12 490
参考になったと評価
8人が参考になったと評価しています。
その他の取扱説明書
54162 view
26389 view
21096 view
21244 view
23290 view
もっと見る