ジュリエッタの取扱説明書・マニュアル [全292ページ 13.06MB]
94995.pdf
http://153.127.244.43/.../94995.pdf - 13.06MB
- キャッシュ
71158view
292page / 13.06MB
If the engine is stopped with the lever in “automatic” position, when itis next started no wiping cycle will take place even if it is raining.This prevents accidental activation of the rain sensor when the engineis started (e.g. when the windscreen is being washed by hand orthe wipers are stuck to the windscreen when there is ice).To restore automatic operation of the rain sensor, turn the ring nut onthe right stalk A fig. 40 from automatic position (AUTO) to O positionand then turn A ring nut back to the AUTO position.When the rain sensor is reactivated using any of the manoeuvresdescribed above, reactivation is indicated by a single stroke of thewindscreen wipers, regardless of the condition of the windscreen.If the sensitivity is changed whilst the rain sensor is operating, awindscreen wiper stroke is carried out to confirm the change.In the event of malfunction of the rain sensor whilst it is active, thewindscreen wiper operates intermittently at a speed consistent with thesensitivity setting of the rain sensor, regardless of whether there israin on the glass (sensor failure is indicated on the display).The sensor continues to operate and it is possible to set the windscreenwiper to continuous mode (1stor 2ndspeed). The failure indicationremains for as long as the sensor is active.REAR WINDOW WASHER/WIPER (for versions/markets, where provided)ActivationThis operates only with the ignition key turned to MAR.Turn ring nut B fig. 40 from position O to positionto operate therear window wiper as follows:❒ in intermittent mode when the windscreen wiper is not operating;❒ in synchronous mode (at half the speed of the windscreen wiper)when the windscreen wiper is operating;❒ in continuous mode with reverse gear engaged and the controlactive.With reverse gear engaged and windscreen wiper on, the rearwindow wiper is activated in continuous mode. Pushing the stalktowards the dashboard (unstable position) will activate the rearwindow washer jet.Keep the stalk pushed for more than half a second to activate the rearwindow wiper as well. Releasing the stalk will activate the smart67GETTING TOKNOW YOUR CARSAFETYSTARTING ANDDRIVINGIN AN EMERGENCYSERVICING ANDMAINTENANCETECHNICALSPECIFICATIONSINDEX
参考になったと評価
65人が参考になったと評価しています。