ジュリエッタの取扱説明書・マニュアル [全292ページ 13.06MB]
94995.pdf
http://153.127.244.43/.../94995.pdf - 13.06MB
- キャッシュ
71298view
292page / 13.06MB
❒ alert any bystander that the car is about to be raised; all personsshould be kept away from the car and nobody must touch it untilit has been lowered;❒ fit handle D fig. 124 into the housing in device A, operate the jackand raise the car until the wheel is a few centimetres from theground;❒ for versions with wheel cap, remove the wheel cap after looseningthe 4 fastening bolts and finally loosen the fifth bolt and extract thewheel;❒ make sure the contact surfaces between space-saver wheel and hubare clean so that the fastening bolts will not come loose;❒ fit the space-saver spare wheel by inserting the first bolt for twothreads into the hole closest to the valve;❒ take the wrench A fig. 123 and fully tighten the fixing bolts;❒ operate the jack handle D fig. 124 to lower the vehicle. Then extractthe jack;❒ use the wrench A fig. 123 provided to fully tighten the bolts in acriss-cross fashion as per the numerical sequence illustrated infig. 126;❒ when replacing an alloy wheel it is advisable to place it upsidedown, with the aesthetic part facing upwards.Visit Alfa Romeo Authorized Services as soon as possible tocheck the correct tightening of the main wheel bolts.Restore the standard wheel as soon as possible, because, once placedin the associated compartment, the luggage compartment loadplatform is rendered uneven as the standard wheel is larger than thespace-saver wheel.REMOVING THE SUBWOOFER(versions with Bose HI-FI system)(for versions/markets, where provided)IMPORTANT The following procedure only applies to cars equippedwith Bose HI-FI systems with subwoofer (for versions/markets, whereprovided).Subwoofer and space-saver spare wheelOn these versions, the tools needed for changing the wheel arearranged in a specific container on the left-hand side of the boot (seefig. 127).The jack is located in a pocket, again on the left-hand side of the boot(see fig. 128).Proceed as follows to remove the Subwoofer:❒ open the boot, pull the tab A fig. 121, lift the mat upwards andremove the load compartment shim fig. 127;❒ loosen the fastening device A fig. 129, remove the clip B fasteningthe cable and then lift the subwoofer;fig. 126A0K0040146GETTING TO KNOWYOUR CARSAFETYSTARTING ANDDRIVINGIN ANEMERGENCYSERVICING ANDMAINTENANCETECHNICALSPECIFICATIONSINDEX
参考になったと評価
65人が参考になったと評価しています。