シボレーサバーバンの取扱説明書・マニュアル [全578ページ 3.04MB]
2009_chevrolet_suburban_owners.pdf
http://www.chevrolet.com/.../2009_chevrolet_suburban_owners.pdf - 3.04MB
- キャッシュ
66072view
578page / 3.04MB
Shifting Out of Four-Wheel Drive LowTo shift from Four-Wheel Drive Low to Four-WheelDrive High, AUTO, or Two-Wheel Drive High, the vehiclemust be stopped or moving less than 3 mph (5 km/h)with the transmission in N (Neutral) and the ignitionin ON/RUN. The preferred method for shifting out ofFour-Wheel Drive Low is to have your vehicle moving1 to 2 mph (1.6 to 3.2 km/h). Turn the knob to theFour-Wheel Drive High, AUTO, or Two-Wheel Drive Highposition. You must wait for the Four-Wheel Drive High,AUTO, or Two-Wheel Drive High indicator light to stopflashing and remain on before shifting the transmissioninto gear.Notice:Shifting the transmission into gear beforethe Four-Wheel Drive Low indicator light hasstopped flashing could damage the transfer case.To help avoid damaging the vehicle, always wait forthe Four-Wheel Drive Low indicator light to stopflashing before shifting the transmission into gear.The vehicle may have significant engagement noiseand bump when shifting between Four-Wheel Drive Lowand Four-Wheel Drive High ranges or from N (Neutral)while the engine is running.If the knob is turned to the Four-Wheel Drive High,AUTO, or Two-Wheel Drive High switch position whenthe vehicle is in gear and/or moving, the Four-WheelDrive High, AUTO or Two-Wheel Drive High indicatorlight will flash for 30 seconds but will not completethe shift unless the vehicle is moving less than 3 mph(5 km/h) and the transmission is in N (Neutral).Shifting into NeutralTo shift the transfer case to N (Neutral) do the following:1. Make sure the vehicle is parked so that it willnot roll.2. Set the parking brake and apply the regular brakepedal. SeeParking Brake on page 2-45 for moreinformation.3. Start the vehicle or turn the ignition to ON/RUN.4. Put the transmission in N (Neutral).5. Shift the transfer case to Two-Wheel Drive High.6. Turn the transfer case dial clockwise to N (Neutral)until it stops and hold it there until the N (Neutral)light starts blinking. This will take at least10 seconds. Then slowly release the dial to theFour-Wheel Drive Low position. The N (Neutral)light will come on when the transfer case shift toN (Neutral) is complete.2-43
参考になったと評価
33人が参考になったと評価しています。
その他の取扱説明書
837 view
2916 view
718 view
716 view