シボレーサバーバンの取扱説明書・マニュアル [全578ページ 3.04MB]
2009_chevrolet_suburban_owners.pdf
http://www.chevrolet.com/.../2009_chevrolet_suburban_owners.pdf - 3.04MB
- キャッシュ
66072view
578page / 3.04MB
Setting Cruise ControlCruise control will not work if the parking brake is set,or if the master cylinder brake fluid level is low.The cruise control light on the instrument panel clustercomes on after the cruise control has been set tothe desired speed.{ CAUTION:If you leave your cruise control on when you arenot using cruise, you might hit a button and gointo cruise when you do not want to. You could bestartled and even lose control. Keep the cruisecontrol switch off until you want to use cruisecontrol.1. Press theI button.2. Get up to the desired speed.3. Press the SET−button located on the steeringwheel and release it.4. Take your foot off the accelerator.Resuming a Set SpeedIf the cruise control is set at a desired speed and then thebrakes are applied, this shuts off the cruise control. But itdoes not need to be reset.Once the vehicle speed reaches about 25 mph (40 km/h)or more, press the +RES button on the steering wheel.The vehicle returns to the previously set speed and staysthere.Increasing Speed While Using CruiseControlTo increase the cruise speed while using cruise control: Press and hold the +RES button on the steeringwheel until the desired speed is reached, thenrelease it. To increase vehicle speed in small increments,press the +RES button. Each time this is done,the vehicle goes about 1 mph (1.6 km/h) faster.3-13
参考になったと評価
33人が参考になったと評価しています。
その他の取扱説明書
837 view
2916 view
718 view
716 view