シボレーサバーバンの取扱説明書・マニュアル [全578ページ 3.04MB]
2009_chevrolet_suburban_owners.pdf
http://www.chevrolet.com/.../2009_chevrolet_suburban_owners.pdf - 3.04MB
- キャッシュ
66072view
578page / 3.04MB
BrakesBrake FluidThe brake mastercylinder reservoir is filledwith DOT 3 brake fluid.SeeEngine CompartmentOverview on page 5-14 forthe location of the reservoir.There are only two reasons why the brake fluid level inthe reservoir might go down: The brake fluid level goes down because of normalbrake lining wear. When new linings are installed,the fluid level goes back up. A fluid leak in the brake hydraulic system can alsocause a low fluid level. Have the brake hydraulicsystem fixed, since a leak means that sooneror later the brakes will not work well.Do not top off the brake fluid. Adding fluid does notcorrect a leak. If fluid is added when the liningsare worn, there will be too much fluid when new brakelinings are installed. Add or remove brake fluid, asnecessary, only when work is done on the brakehydraulic system.{ CAUTION:If too much brake fluid is added, it can spill on theengine and burn, if the engine is hot enough. Youor others could be burned, and the vehicle couldbe damaged. Add brake fluid only when work isdone on the brake hydraulic system. SeeChecking Brake Fluid in this section.When the brake fluid falls to a low level, the brakewarning light comes on. See Brake System WarningLight on page 3-40.Refer to the Maintenance Schedule to determine whento check the brake fluid. See Scheduled Maintenanceon page 6-4.5-40
参考になったと評価
33人が参考になったと評価しています。
その他の取扱説明書
837 view
2916 view
718 view
716 view