シボレーサバーバンの取扱説明書・マニュアル [全578ページ 3.04MB]
2009_chevrolet_suburban_owners.pdf
http://www.chevrolet.com/.../2009_chevrolet_suburban_owners.pdf - 3.04MB
- キャッシュ
66072view
578page / 3.04MB
5. After entering all of the switch positions, again,firmly press and release all three buttons at thesame time. The indicator lights will turn on.6. Press and hold the button that will be used tocontrol the garage door until the garage doormoves. The indicator light above the selected buttonshould slowly blink. This button may need to beheld for up to 55 seconds.7. Immediately release the button when the garagedoor moves. The indicator light will blink rapidlyuntil programming is complete.8. Press and release the same button again.The garage door should move, confirmingthat programming is successful and complete.To program another Fixed Code device such as anadditional garage door opener, a security device,or home automation device, repeat Steps 1-8, choosinga different button in Step 6 than what was used forthe garage door opener.Using Universal Home RemotePress and hold the appropriate button for at leasthalf of a second. The indicator light will come on whilethe signal is being transmitted.Reprogramming Universal HomeRemote ButtonsAny of the three buttons can be reprogrammed byrepeating the instructions.Erasing Universal Home RemoteButtonsThe programmed buttons should be erased when thevehicle is sold or the lease ends.To erase either Rolling Code or Fixed Code on theUniversal Home Remote device:1. Press and hold the two outside buttons at thesame time for approximately 20 seconds, untilthe indicator lights, located directly above thebuttons, begin to blink rapidly.2. Once the indicator lights begin to blink, release bothbuttons. The codes from all buttons will be erased.For help or information on the Universal Home RemoteSystem, call the customer assistance phone numberunderCustomer Assistance Offices on page 7-6 .2-77
参考になったと評価
33人が参考になったと評価しています。
その他の取扱説明書
837 view
2916 view
718 view
716 view