シボレートレイルブレイザーの取扱説明書・マニュアル [全432ページ 2.90MB]
103530.pdf
http://153.127.246.254/.../103530.pdf - 2.90MB
- キャッシュ
55272view
432page / 2.90MB
2-693. Return to HomeLink in your vehicle and firmly press and release the programmed HomeLink buttonthree times.The rolling-code garage door opener should nowrecognize HomeLink. You may either use HomeLink orthe hand-held transmitter to open the garage door.If after following these instructions, you still haveproblems training the garage door opener, contact themanufacturer of HomeLink at 1-800 -355 -3515, or onthe internet at www.homelink.com.Canadian ProgrammingCanadian Owners: During programming, thehand-held transmitter may automatically stoptransmitting after two seconds. In this case, you shouldpress and hold the HomeLink button (see Steps 2 and 3 under "Programming the HomeLink Transmitter")while you press and re-press (cycle) your hand -heldtransmitter every two seconds until HomeLink is trained.Operating the HomeLink TransmitterPress and hold the appropriate button on HomeLink forat least half of a second. The indicator light will comeon while the signal is being transmitted.Erasing ChannelsTo erase all three programmed channels, hold down thetwo outside buttons until the indicator light begins toflash (approximately 20 seconds). Release both buttons.Resetting DefaultsTo reset HomeLink to default settings, hold down thetwo outside buttons until the indicator light begins toflash (approximately 20 seconds). Continue to hold bothbuttons until the HomeLink indicator light turns off andthen release both buttons.AccessoriesAccessories for the HomeLink Transmitter are availablefrom the manufacturer of the unit. If you would likeadditional information, please contact the manufacturerof HomeLink at 1-800 -355 -3515, or on the internet at www.homelink.com.
参考になったと評価
15人が参考になったと評価しています。
その他の取扱説明書
2200 view
452 view
640 view
388 view
857 view
もっと見る