CAPTAIN'S SEATSTo recline,pull up the recline control located below the inboard arm rest and lean back.To slide the seat of Dodge models,pull the slide control located on the left underside of the seat outward,and slidethe seat either forward or back. On Chevrolet models,pull the slide control located on the front lower side of theseat upward,and slide the seat either forward or back.To swivel the seats from a forward facing position to a rearward facing position,be aware of the following:i) Ensure that the back of the seat is reclined as far forward as the recline control allows.ii) Slide the seat forward but not so far as to lose clearance of the engine cover.iii) Put the tilt steering wheel in the uppermost position.iv) The swivel control is located on the center front underside of the seat and locks the seat in a forwardfacing position. To release,pull up on the swivel control and turn the seat inward (clockwise for the driverside seat and counterclockwise for the passenger seat).v) Swivel the seat to the desired position.vi) Once completed,lower the tilt steering wheel and adjust the recline and slide controls as desired.SEAT BELT USAGEFor protection,while your vehicle is in motion,everybody inside the vehicle must wear a seat belt. The driver andpassenger captains seats and the lounge seat(s) immediately behind are designed to carry passengers while yourvehicle is in motion and are equipped with seat belts installed for their protection. All passengers must be seatedin these seats only with seat belts fastened while the vehicle is in motion.Some vans are equipped with lap belts for extra seating while in motion (forward facing seats in an L-shapedlounge option). The lap belts must be worn across the hips and not across the abdomen. Passengers must sit wellback in the seat and in an upright position.DINETTE TABLE (190-VERSATILE WITH DINETTE ONLY)The rear dinette table can be used with the front captain's seats and lounge seats (without removable wardrobe)instead of the cloverleaf dining table. To use the dinette table at the front:i) Remove the cloverleaf table from its table leg.ii) Leave the table leg in the base in the floor at the front.iii) Swivel the driver captain's seat into a rearward facing position (see Captain's Seats A-1).iv) Place the dinette table on this table leg with the other end resting on the drink holders mounted on thewall below the awning window.DAILY LIVINGDoc No:MNSA0006 Rev:00Copyright(C) Hanmar Motor Corporation 203 A-1CAPTAIN'S SEATSTo recline,pull up the recline control located below the inboard arm rest and lean back.To slide the seat of Dodge models,pull the slide control located on the left underside of the seat outward,and slidethe seat either forward or back. On Chevrolet models,pull the slide control located on the front lower side of theseat upward,and slide the seat either forward or back.To swivel the seats from a forward facing position to a rearward facing position,be aware of the following:i) Ensure that the back of the seat is reclined as far forward as the recline control allows.ii) Slide the seat forward but not so far as to lose clearance of the engine cover.iii) Put the tilt steering wheel in the uppermost position.iv) The swivel control is located on the center front underside of the seat and locks the seat in a forwardfacing position. To release,pull up on the swivel control and turn the seat inward (clockwise for the driverside seat and counterclockwise for the passenger seat).v) Swivel the seat to the desired position.vi) Once completed,lower the tilt steering wheel and adjust the recline and slide controls as desired.SEAT BELT USAGEFor protection,while your vehicle is in motion,everybody inside the vehicle must wear a seat belt. The driver andpassenger captains seats and the lounge seat(s) immediately behind are designed to carry passengers while yourvehicle is in motion and are equipped with seat belts installed for their protection. All passengers must be seatedin these seats only with seat belts fastened while the vehicle is in motion.Some vans are equipped with lap belts for extra seating while in motion (forward facing seats in an L-shapedlounge option). The lap belts must be worn across the hips and not across the abdomen. Passengers must sit wellback in the seat and in an upright position.DINETTE TABLE (190-VERSATILE WITH DINETTE ONLY)The rear dinette table can be used with the front captain's seats and lounge seats (without removable wardrobe)instead of the cloverleaf dining table. To use the dinette table at the front:i) Remove the cloverleaf table from its table leg.ii) Leave the table leg in the base in the floor at the front.iii) Swivel the driver captain's seat into a rearward facing position (see Captain's Seats A-1).iv) Place the dinette table on this table leg with the other end resting on the drink holders mounted on thewall below the awning window.DAILY LIVINGDoc No:MNSA0006 Rev:00Copyright(C) Hanmar Motor Corporation 203 A-1
