DAILY LIVINGDoc No:MNSA0006 Rev:00Copyright(C) Hanmar Motor Corporation 203 B-3FRONT LOUNGE SEATS (ALL MODELS)To convert the lounge seat into a single bed:i) For the driver side seat of Dodge models,swivel the driver captain's seat 270 degrees clockwise (seeCaptain's Seats A-1) so that it is facing outward towards the door. For the passenger side seat of Dodgemodels,swivel the passenger captain's seat 270 degrees counterclockwise (see Captain's Seats A-1) sothat it is facing inward towards the driver seat. Be sure all arm rests are in an upright position.ii) For the driver side seat of Chevrolet models,swivel the driver captain's seat 90 degrees counter clockwise(see A.1.) so that it is facing outward towards the door. For the passenger side seat of Chevrolet models,swivel the passenger captain's seat 90 degrees clockwise (see Captain's Seats A-1) so that it is facinginward towards the driver seat. Be sure all arm rests are in an upright position.iii) Lift the back rest cushion upward,remove it from its metal support and place it flat on the seat cushion.iv) Lift up the seat cushion and pull forward until it is up against the swiveled captain's seat.v) Swing down the hinged support board (located on the galley or closet partition).vi) Place the back rest cushion with the upper edge against the galley or closet partition. (Take care toensure that the back rest cushion's upholstery is not damaged by its metal support located on the galleyor closet partition.) vii) Push flat so that the round knobs (located on the back of the back rest) are inside the seat base box.To convert back to a lounge seat,perform these steps in reverse order. When placing the seat cushion back inplace,be sure to slide it in all the way back towards the galley partition and then down securely in place.DAILY LIVINGDoc No:MNSA0006 Rev:00Copyright(C) Hanmar Motor Corporation 203 B-3FRONT LOUNGE SEATS (ALL MODELS)To convert the lounge seat into a single bed:i) For the driver side seat of Dodge models,swivel the driver captain's seat 270 degrees clockwise (seeCaptain's Seats A-1) so that it is facing outward towards the door. For the passenger side seat of Dodgemodels,swivel the passenger captain's seat 270 degrees counterclockwise (see Captain's Seats A-1) sothat it is facing inward towards the driver seat. Be sure all arm rests are in an upright position.ii) For the driver side seat of Chevrolet models,swivel the driver captain's seat 90 degrees counter clockwise(see A.1.) so that it is facing outward towards the door. For the passenger side seat of Chevrolet models,swivel the passenger captain's seat 90 degrees clockwise (see Captain's Seats A-1) so that it is facinginward towards the driver seat. Be sure all arm rests are in an upright position.iii) Lift the back rest cushion upward,remove it from its metal support and place it flat on the seat cushion.iv) Lift up the seat cushion and pull forward until it is up against the swiveled captain's seat.v) Swing down the hinged support board (located on the galley or closet partition).vi) Place the back rest cushion with the upper edge against the galley or closet partition. (Take care toensure that the back rest cushion's upholstery is not damaged by its metal support located on the galleyor closet partition.) vii) Push flat so that the round knobs (located on the back of the back rest) are inside the seat base box.To convert back to a lounge seat,perform these steps in reverse order. When placing the seat cushion back inplace,be sure to slide it in all the way back towards the galley partition and then down securely in place.
