TOILETSee appropriate component Manufacturer's Owners Manual for operating instructions.STAND-UP AISLE SHOWERTo set up the stand-up aisle shower:i) If possible,park your vehicle sloping slightly to the rear to prevent water from running to the front of thelowered floor while showering (otherwise,any excess water can be directed towards the drain with atowel).ii) Extend all privacy doors (see Privacy Doors D-1).iii)Remove drain plug from floor.iv) Release the Velcro retention straps and place the hand held shower head in the holder on the shelf.v) Draw the shower curtain until you are completely surrounded.vi) Using the Velcro connectors,secure the edges of the curtain together allowing the shower hose to hangwithin the shower area to retain any dripping water inside the curtains.vii) When adjusting the water temperature,be sure to allow enough time for the temperature adjusted waterto exit the shower head before making further adjustments.viii)To conserve water,discontinue the water flow at the shower head between wetting and rinsing.To put away the stand-up shower:i) Rinse and dry the shower curtain thoroughly (this function is most easily performed before leaving theshower area after use).ii) Allow the curtain to air dry completely this function can be expedited by operation the power roof vent.iii) Follow the above instructions for stand-up shower set up in reverse order.iv)Replace drain plug in floor when finished.To prevent grey water tank contents from spilling onto the floor while driving,keep the drain plugsecured at all times.DAILY LIVINGDoc No:MNSA0006 Rev:00Copyright(C) Hanmar Motor Corporation 203 D-2TOILETSee appropriate component Manufacturer's Owners Manual for operating instructions.STAND-UP AISLE SHOWERTo set up the stand-up aisle shower:i) If possible,park your vehicle sloping slightly to the rear to prevent water from running to the front of thelowered floor while showering (otherwise,any excess water can be directed towards the drain with atowel).ii) Extend all privacy doors (see Privacy Doors D-1).iii)Remove drain plug from floor.iv) Release the Velcro retention straps and place the hand held shower head in the holder on the shelf.v) Draw the shower curtain until you are completely surrounded.vi) Using the Velcro connectors,secure the edges of the curtain together allowing the shower hose to hangwithin the shower area to retain any dripping water inside the curtains.vii) When adjusting the water temperature,be sure to allow enough time for the temperature adjusted waterto exit the shower head before making further adjustments.viii)To conserve water,discontinue the water flow at the shower head between wetting and rinsing.To put away the stand-up shower:i) Rinse and dry the shower curtain thoroughly (this function is most easily performed before leaving theshower area after use).ii) Allow the curtain to air dry completely this function can be expedited by operation the power roof vent.iii) Follow the above instructions for stand-up shower set up in reverse order.iv)Replace drain plug in floor when finished.To prevent grey water tank contents from spilling onto the floor while driving,keep the drain plugsecured at all times.
