ELECTRICAL SYSTEMDoc No:MNSA0006 Rev:00Copyright(C) Hanmar Motor Corporation 203 F-1Your vehicle's electrical system should not be subjected to changes and/or additions to circuitry,appliances,etc.without consulting your dealer for proper installation procedures.110/12V CONVERTER/CHARGERFor your convenience when camping in parks with hookups for 110V power all our models have in the electricalsystem a 110/12V converter/charger. The converter reduces the voltage from 110V to 12V and distributes thepower to all 12V house appliances and lights as well as it recharges all batteries present in the system. Theconverter/charger is incorporated in the main electrical distribution panel with all 110V and 12V breakers. Seesection C.0.for convertor/charger location. To open the access door to the converter,twist the square locking knob1/4 turn and pull open. All breakers/circuits are identified on the panel. See 110/12V converter/chargerManufacturer's Owner's Manuals for operating instructions.NOTICE:In the event that your refrigerator stops cooling while being operated by 120 volt AC (Chevrolet only),and thecorresponding breaker is not tripped,check the GFCI receptacle located in the driver side lounge box,and reset if tripped.EXTERNAL ELECTRICAL SOURCE CONNECTIONYour vehicle is equipped with a heavy duty 30 amp.power cord so that you can connect your electrical system toan outside 110V (in Canada) or 120V (in U.S.) power source. On Dodge models,the power cord is stored in thestorage compartment located behind the large lockable access door integrated within the running boards on thedriver side. On Chevrolet models,it is integrated into the flare behind the driver side rear wheel. A 30 to 15 amp.adapter is not included with your vehicle.Notice:When connecting your system to an outside source,ensure that a properly equipped (threepronged) and functioning receptacle is used. If any type of spark or shock is detected,disconnect from thesource immediately and do not reconnect until the problem is corrected.GENERATOR (OPTIONAL)All service requirements are listed in the Generator Owners Manual.The generator is located and accessed on the underside behind the rear axle of your vehicle.CAUTION: When launching a boat,generators are not to be submerged in water. This will permanentlydamage the generator. If you cannot launch without submerging the generator,an alternate method is to use aboat launching service.BUILT-IN 110V AIR CONDITIONERIn addition to the operating instructions contained in the Manufacturer's Owner's Manual,the air conditionershould be started as follows when the optional generator is used:i) Start the generator and operate for several minutes until warm.ii) Ensure the thermostat is set at its warmest setting (1).iii) Turn air conditioner master control to "low cool" position.iv) Adjust the thermostat cooler (towards "8") until the compressor starts.v) Once the compressor is running,adjust master control and thermostat to desired settings.Your vehicle should be parked as close to level as possible to maximize the air conditioner's efficiency. In ahumid environment some water will condense when the air is blown through the cold side of the airconditioner. The water accumulates in a pan under the air conditioner and drains away at the back of thevan. From time to time water may spill from the front of the air conditioner during abrupt stops or whileparked on a steep forward slope.ELECTRICAL SYSTEMDoc No:MNSA0006 Rev:00Copyright(C) Hanmar Motor Corporation 203 F-1Your vehicle's electrical system should not be subjected to changes and/or additions to circuitry,appliances,etc.without consulting your dealer for proper installation procedures.110/12V CONVERTER/CHARGERFor your convenience when camping in parks with hookups for 110V power all our models have in the electricalsystem a 110/12V converter/charger. The converter reduces the voltage from 110V to 12V and distributes thepower to all 12V house appliances and lights as well as it recharges all batteries present in the system. Theconverter/charger is incorporated in the main electrical distribution panel with all 110V and 12V breakers. Seesection C.0.for convertor/charger location. To open the access door to the converter,twist the square locking knob1/4 turn and pull open. All breakers/circuits are identified on the panel. See 110/12V converter/chargerManufacturer's Owner's Manuals for operating instructions.NOTICE:In the event that your refrigerator stops cooling while being operated by 120 volt AC (Chevrolet only),and thecorresponding breaker is not tripped,check the GFCI receptacle located in the driver side lounge box,and reset if tripped.EXTERNAL ELECTRICAL SOURCE CONNECTIONYour vehicle is equipped with a heavy duty 30 amp.power cord so that you can connect your electrical system toan outside 110V (in Canada) or 120V (in U.S.) power source. On Dodge models,the power cord is stored in thestorage compartment located behind the large lockable access door integrated within the running boards on thedriver side. On Chevrolet models,it is integrated into the flare behind the driver side rear wheel. A 30 to 15 amp.adapter is not included with your vehicle.Notice:When connecting your system to an outside source,ensure that a properly equipped (threepronged) and functioning receptacle is used. If any type of spark or shock is detected,disconnect from thesource immediately and do not reconnect until the problem is corrected.GENERATOR (OPTIONAL)All service requirements are listed in the Generator Owners Manual.The generator is located and accessed on the underside behind the rear axle of your vehicle.CAUTION: When launching a boat,generators are not to be submerged in water. This will permanentlydamage the generator. If you cannot launch without submerging the generator,an alternate method is to use aboat launching service.BUILT-IN 110V AIR CONDITIONERIn addition to the operating instructions contained in the Manufacturer's Owner's Manual,the air conditionershould be started as follows when the optional generator is used:i) Start the generator and operate for several minutes until warm.ii) Ensure the thermostat is set at its warmest setting (1).iii) Turn air conditioner master control to "low cool" position.iv) Adjust the thermostat cooler (towards "8") until the compressor starts.v) Once the compressor is running,adjust master control and thermostat to desired settings.Your vehicle should be parked as close to level as possible to maximize the air conditioner's efficiency. In ahumid environment some water will condense when the air is blown through the cold side of the airconditioner. The water accumulates in a pan under the air conditioner and drains away at the back of thevan. From time to time water may spill from the front of the air conditioner during abrupt stops or whileparked on a steep forward slope.
