PT-LB90NTの取扱説明書・マニュアル [全68ページ 8.58MB]
cb9b3cf2-6572-4b42-97aa-319a89d99e77.pdf
gizport - 2013-08-16
http://dl.owneriq.net/.../cb9b3cf2-6572-4b42-97aa-319a89d99e77.pdf - 8.58MB
- キャッシュ
25994view
68page / 8.58MB
Switching the projector on/offBasic Operation22 - ENGLISHSwitching off the projectorWhen operating the projector, check the status of the POWER indicator. (AEpage 20)INPUT SELECTRELEASEPOWER indicatorPOWER LOCK indicator(1), (2)Press the POWER button.1 ) The conirmation screen will be displayed.Without any operation for 10 seconds or press any button other than the zPOWER button, the conirmation screen will go off and return to the projection.Press the POWER button again.2 ) The lamp goes off, the operational sound (beep) sounds, and projection stops.The cooling fan continues its rotation and zPOWER indicator lights in orange. Wait until the POWER LOCK indicator and POWER indicator turn into red.If zSTANDBY MODE is set to NORMAL, the POWER indicator lashes in red. (AEpage 40)You can set to zON or OFF the beeping sound that occurs when the POWER button is in operation in AUDIO SETTING. (AEpage 41)After the POWER LOCK indicator and POWER indicator light in red, disconnect the 3 ) power plug from the wall outlet. (AEpage 19)For urgency, you may disconnect the power plug immediately since the zDIRECT POWER OFF function is installed.RemarksConirm that zCONTROL PANEL (when operating with the projector body) or REMOTE CONTROLLER (when operating with the remote control) under CONTROL DEVICE SETUP in the SECURITY menu is set to ENABLE . (AEpage 44)You can switch off the power by pressing the zPOWER button for 0.5 seconds or more.
参考になったと評価
12人が参考になったと評価しています。
この取扱説明書が関連付けられている製品