PT-LB90NTの取扱説明書・マニュアル [全68ページ 8.58MB]
cb9b3cf2-6572-4b42-97aa-319a89d99e77.pdf
gizport - 2013-08-16
http://dl.owneriq.net/.../cb9b3cf2-6572-4b42-97aa-319a89d99e77.pdf - 8.58MB
- キャッシュ
25994view
68page / 8.58MB
Switching the projector on/offBasic OperationENGLISH - 21Switching on the projectorBefore switching on the projector, make sure the power cord and all the other devices are connected correctly. (AEpage 17)INPUT SELECTRELEASEPOWER indicatorPOWER LOCK indicator(2)(3)Connect the power cord. 1 ) (AEpage 19)The POWER LOCK indicator and POWER indicator light in red.Press the RELEASE button to unlock the POWER button.2 ) The POWER LOCK indicator goes off.When operating with the remote control, you do not need to press the zRELEASE button.Press the POWER button.3 ) The POWER button beeps once.You can turn zON or OFF the beeping sound that occurs when you press the POWER button by menu setting. (AEpage 41)The zPOWER indicator lashes in green several times, then the POWER indicator lights up and the STARTUP LOGO is displayed. See “STARTUP LOGO” in the “DISPLAY OPTION” menu. (AEpage 37)NoteOperating the control panel buttons with covered hand, such as plastered or gloved, may result in operating zerrors.RemarksConirm that zCONTROL PANEL (when operating with the projector body) or REMOTE CONTROLLER (when operating with the remote control) under CONTROL DEVICE SETUP in the SECURITY menu is set to ENABLE. (AEpage 44)The projector does not operate when the zPOWER button of the projector body is pressed while it is locked.If the zPOWER button is not being pressed in 10 seconds after the RELEASE button is pressed, the POWER LOCK indicator lights in red and the POWER button remains locked. Press the RELEASE button again to unlock.When starting up the projector, some small rattling or tinkling sound may be heard. Those are normal and will znot affect the performance of the projector.When the internal cooling fan is operating, some operational sound may be heard. The loudness of the zoperational sound depends on the external temperature.If zINITIAL START UP in the PROJECTOR SETUP menu is set to ON, the projector starts projecting when the power cord is connected to a wall outlet. (AEpage 39)If the projector is switched on again while the internal cooling fan is still operating by the internal power supply, zthe display may licker for the characteristics of the lamp. Those are normal and will not affect the performance of the projector.
参考になったと評価
12人が参考になったと評価しています。
この取扱説明書が関連付けられている製品