PT-LB90NTの取扱説明書・マニュアル [全68ページ 8.58MB]
cb9b3cf2-6572-4b42-97aa-319a89d99e77.pdf
gizport - 2013-08-16
http://dl.owneriq.net/.../cb9b3cf2-6572-4b42-97aa-319a89d99e77.pdf - 8.58MB
- キャッシュ
25994view
68page / 8.58MB
PROJECTOR SETUP menuSettingsENGLISH - 39PROJECTOR SETUP menuNavigating through the MENU (AEpage 27) , select PROJECTOR SETUP from the main menu and then select the required item from the sub-menu.Set the selected item with◄►buttons. zRemote control Control panelSTATUSYou can check the using status of the projector.SIGNAL JNAME: Name of input signal zFREQUENCY: Scanning frequency of input zsignalRUNTIME JPROJECTOR: Display current usage time of zprojectorLAMP: Display current usage time of lamp zNO SIGNAL SHUT-OFFIf no image signal is input for the time set with the timer, the projector will enter into standby mode automatically.Change settingChange settingDISABLENO SIGNAL SHUT-OFF is disabled15 - 60 MIN.Timer can be set in intervals of 5 minutesINITIAL START UPYou can set the starting method when the power plug is connected to wall outlet.Change settingChange settingLAST MEMORYProjector starts from the last image before the power plug was disconnectedSTANDBYProjector starts in the standby modeONProjector starts immediatelyINSTALLATIONWhen installing the projector, select the projection method according to the projector position. (AEpage 16)Change settingChange settingFRONT/ DESKSetting on a desk/loor and projecting from frontFRONT/ CEILINGMounting in the ceiling with a ceiling mount bracket (sold separately) and projecting from frontREAR/DESKSetting on a desk/loor and projecting from rear (Translucent screen is required)REAR/CEILINGMounting in the ceiling with a ceiling mount bracket (sold separately) and projecting from rear (Translucent screen is required)HIGH ALTITUDE MODEIf you use the projector at high elevation, the HIGH ALTITUDE MODE setting need to be ON to set the fan speed high.Change settingChange settingOFFFor use in normal environmentONFor use at high altitudeRemarksAt 1 400 -2 700 m (4 593 - 8 858 ft) sea level, the zsetting must be ON.The loudness of fan noise depends on the zHIGH ALTITUDE MODE setting.
参考になったと評価
12人が参考になったと評価しています。
この取扱説明書が関連付けられている製品