PT-LB90NTの取扱説明書・マニュアル [全68ページ 8.58MB]
cb9b3cf2-6572-4b42-97aa-319a89d99e77.pdf
gizport - 2013-08-16
http://dl.owneriq.net/.../cb9b3cf2-6572-4b42-97aa-319a89d99e77.pdf - 8.58MB
- キャッシュ
25994view
68page / 8.58MB
Care and ReplacementMaintenanceENGLISH - 49 JLamp replacement procedureWhen the projector is mounted in the ceiling, do not work directly under the projector or put your face close zto the projector.Be sure to install the lamp unit and attach the lamp unit cover securely. If they are not installed securely, it zmay cause the protection circuit to operate so that the power cannot be turned on.Disconnect the power plug from the wall outlet according to “Switching off the 1 ) projector” (AEpage 22), wait for at least 1 hour, and check if the lamp unit bottom is cooled.Use a Phillips-head screwdriver to loosen the 2 lamp unit cover ixing screws on the 2 ) back of the projector until the screws turn loose, and remove the lamp unit cover.Lamp unit cover ixing screwsLamp unit coverUse a Phillips-head screwdriver to loosen the 3 lamp unit ixing screws. Pull the 3 ) used lamp unit gently from the projector.HandlesLamp unit ixing screwsPress in the lamp unit until it clicks and make sure the unit is installed securely. 4 ) Tighten the 3 lamp unit ixing screws securely with a Phillips-head screwdriver.When inserting, in particular press the portion of securely. Lamp unit cover ixing screws
参考になったと評価
12人が参考になったと評価しています。
この取扱説明書が関連付けられている製品