X3の取扱説明書・マニュアル [全144ページ 4.54MB]
123812.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123812.pdf - 4.54MB
- キャッシュ
7890view
144page / 4.54MB
ReferenceAt a glanceControlsDriving tipsMobility 111Replacing componentsOnboard tool kitThe onboard tool kit is located in the cargo area under the floor panel.To open the panel, grasp the handle, refer to arrow, and pivot upward.Wiper bladesReplacing front wiper blades1. Move the wiper into th e fold-out position, refer to page42 .2. Lift the wiper arm and press the securing spring, refer to arrow.3. Pull the wiper blade of f toward the wiper arm.4. Insert the new blade and snap it into place.To prevent damage to the wipers, always fold them back down onto the windshield before you turn the igni tion key to position 1 or 2 or open the hood. <Replacing rear wiper blade1. Lift the wiper arm.2. Pull off the wiper blade, refer to arrow.3. Insert a new wiper blade.Lamps and bulbsLamps and bulbs make a significant contribu-tion to road safety. Therefore, comply fully with the following instructions during bulb replace-ment. If you are not familiar with the specified procedures or they are not described here, BMW recommends having this work carried out at your BMW Sports Activity Vehicle Center.Never touch the glass of new bulbs with your bare fingers, as even minute amounts of contamination will burn into the bulb's surface and reduce its service life. Use a clean cloth, paper towel, or the like or grasp bulb by its base. <A replacement bulb set is available from your BMW Sports Activity Vehicle Center.In all work on the electrical system, switch off the relevant component to prevent short circuits. To avoid po ssible injury or equip-ment damage when replacing bulbs, follow any instructions provided by the bulb manufac-turer. <When caring for headlamps, please follow the instructions on page 109 .
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
53897 view
26342 view
21056 view
21210 view
23256 view
もっと見る