X3の取扱説明書・マニュアル [全144ページ 4.54MB]
123812.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123812.pdf - 4.54MB
- キャッシュ
7890view
144page / 4.54MB
Replacing components112Please have your BM W Sports Activity Vehicle Center work on lamps whose replacement is not described here. <Light-emitting diodes LEDsLight-emitting diodes installed behind translu-cent lenses serve as the light source for many of the controls and displays in your vehicle. These light-emitting diodes are related to ordinary lasers.Do not remove the covers, and never stare into the unfilter ed light for several hours, as irritation of the retina could result.<Xenon lamps*The service life of these bulbs is very long and the probability of failure is very low, provided that they are not switched on and off an unusual number of times. If one of these bulbs should nevertheless fail, it is po ssible to continue driv-ing with great caution us ing the fog lamps, pro-vided traffic laws in your area do not prohibit this.To avoid risk of potentially fatal injuries due to the extremely high voltages at which these units operate, service work should always be entrusted to qualified personnel. <Halogen low beamsH7 bulb, 55 wattsAlways wear gloves and eye protection - the atmosphere inside the H7 bulb is pressurized. Failure to observe this precaution can lead to injuries sh ould the bulb be dam-aged.<For checking and adjusting headlamp aim, please contact your BMW Sports Activity Vehicle Center. <Driver's side1. Position the screwdri ver from the onboard tool kit and pull off the lamp cover.Exercise caution when handling the screwdriver; otherwise, personal injury can occur or the vehicle can be dam-aged.<2. Press the bulb holder downward and remove.3. Remove the bulb, install a new bulb.4. Place the bulb holder with the lower edge against the bracket and press it in until the lamp base locks into place.Front passenger sideBefore replacing the bulb , remove the reservoir for the windshield wash ing system from the bracket. To do so, unsc rew the screws, refer to arrow, using the screwdriver from the onboard tool kit and set reservoir aside.Bear in mind that th e windshield washing system reservoir is heavy. Failure to take this into account can lead to personal injury or damage to the vehicle. <
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
53897 view
26342 view
21056 view
21210 view
23256 view
もっと見る