シボレーサバーバンの取扱説明書・マニュアル [全578ページ 3.04MB]
2009_chevrolet_suburban_owners.pdf
http://www.chevrolet.com/.../2009_chevrolet_suburban_owners.pdf - 3.04MB
- キャッシュ
66072view
578page / 3.04MB
The passengers temperature setting can be set tomatch the drivers temperature setting by pressing thePASS button and turning off the PASS indicator.When the passengers temperature setting is setdifferent than the drivers setting, the indicator on thePASS button illuminates and both the driver sideand passenger side temperature displays are shown.Automatic OperationAUTO (Automatic): When automatic operation isactive the system will control the inside temperature, theair delivery, and the fan speed.Use the steps below to place the entire system inautomatic mode:1. Press the AUTO button.When AUTO is selected, the display will change toshow the current temperature(s) and AUTO willbe lit on the display. The current delivery mode andfan speed will also be displayed for approximately5 seconds.When AUTO is selected, the air conditioningoperation and air inlet will be automaticallycontrolled. The air conditioning compressor will runwhen the outside temperature is over about40F (4C). The air inlet will normally be set tooutside air. If it is hot outside, the air inlet mayautomatically switch to recirculate inside air to helpquickly cool down the vehicle. The light on thebutton comes on in recirculation.2. Set the drivers and passengers temperature.To find your comfort setting, start with a 74F (23C)temperature setting and allow about 20 minutesfor the system to regulate. Use the drivers orpassengers temperature buttons to adjust thetemperature setting as necessary. If a temperaturesetting of 60F (15C) is chosen, the system remainsat the maximum cooling setting. If a temperaturesetting of 90F (32C) is chosen, the system remainsat the maximum heat setting. Choosing eithermaximum setting will not cause the vehicle to heat orcool any faster.Do not to cover the solar sensor located on the topof the instrument panel near the windshield. This sensorregulates air temperature based on sun load and alsoturns on the headlamps. For more information onthe solar sensor, see Sensors later in this section.To avoid blowing cold air in cold weather, the system willdelay turning on the fan until warm air is available.The length of delay depends on the engine coolanttemperature. Pressing the fan switch will override thisdelay and change the fan to a selected speed.3-26
参考になったと評価
33人が参考になったと評価しています。
その他の取扱説明書
837 view
2916 view
718 view
716 view