シボレーサバーバンの取扱説明書・マニュアル [全578ページ 3.04MB]
2009_chevrolet_suburban_owners.pdf
http://www.chevrolet.com/.../2009_chevrolet_suburban_owners.pdf - 3.04MB
- キャッシュ
66072view
578page / 3.04MB
TRAILER GAIN This setting is displayed anytime theTrailer Brake Display Page is active. This setting can beadjusted from 0.0 to 10.0 with either a trailer connectedor disconnected. To adjust the Trailer Gain, press one ofthe Trailer Gain adjustment buttons located on the TrailerBrake Control Panel. Press and hold a gain button tocause the Trailer Gain to continuously adjust. To turn theoutput to the trailer off, adjust the Trailer Gain setting to0.0 (zero).0.0 (zero) gain is the factory default setting. To properlyadjust trailer gain, see the Trailer Gain AdjustmentProcedure later in this section.TRAILER OUTPUT This is displayed any time atrailer with electric brakes is connected. Output to theelectric brakes is based on the amount of vehicle brakingpresent and relative to the Trailer Gain setting. Output isdisplayed from 0 to 10 bars for each gain setting.The Trailer Output will indicate ------ontheTrailerBrake Display Page whenever the following occur: No trailer is connected. A trailer without electric brakes is connected(no DIC message is displayed). A trailer with electric brakes has becomedisconnected (a CHECK TRAILER WIRINGmessage will also be displayed on the DIC). There is a fault present in the wiring to the electrictrailer brakes (a CHECK TRAILER WIRINGmessage will also be displayed on the DIC). There is a fault in the ITBC system (a SERVICETRAILER BRAKE SYSTEM message will alsobe displayed in the DIC).Manual Trailer Brake ApplyThe Manual Trailer Brake Apply Lever is located onthe Trailer Brake Control Panel and is used to applythe trailers electric brakes independent of the vehiclesbrakes. This lever is used in the Trailer Gain AdjustmentProcedure to properly adjust the power output to thetrailer brakes. Sliding the lever to the left will apply onlythe trailer brakes. The power output to the trailer isindicated in the Trailer Brake Display Page in the DIC.If the vehicles service brakes are applied while usingthe Manual Trailer Brake Apply Lever, the trailer outputpower will be the greater of the two.The trailer and the vehicles brake lamps will come onwhen either vehicle braking or manual trailer brakesare applied.4-63
参考になったと評価
33人が参考になったと評価しています。
その他の取扱説明書
837 view
2916 view
718 view
716 view