1. 取扱説明書・マニュアル >
2. シボレー >
3. 自動車 >
4. シボレーサバーバン の使い方、故障・トラブル対処法 >
5. シボレーサバーバン の取扱説明書・マニュアル

シボレーサバーバンの取扱説明書・マニュアル [全578ページ 3.04MB]

How to Check Automatic TransmissionFluidBecause this operation can be a little difficult, you maychoose to have this done at the dealer/retailer servicedepartment.If you do it yourself, be sure to follow all the instructionshere or you could get a false reading on the dipstick.Notice:Too much or too little fluid can damage yourtransmission. Too much can mean that some of thefluid could come out and fall on hot engine partsor exhaust system parts, starting a fire. Too littlefluid could cause the transmission to overheat.Be sure to get an accurate reading if you check yourtransmission fluid.Wait at least 30 minutes before checking thetransmission fluid level if you have been driving: When outside temperatures are above 90F (32C). At high speed for quite a while. In heavy traffic especially in hot weather. While pulling a trailer.To get the right reading, the fluid should be at normaloperating temperature, which is 180F to 200F(82C to 93C).Get the vehicle warmed up by driving about 15 miles(24 km) when outside temperatures are above 50F(10C). If it is colder than 50F (10C), drive the vehiclein 3 (Third) until the engine temperature gage movesand then remains steady for 10 minutes.A cold fluid check can be made after the vehicle hasbeen sitting for eight hours or more with the engine off,but this is used only as a reference. Let the engine run atidle for five minutes if outside temperatures are 50F(10C) or more. If it is colder than 50F (10C), you mayhave to idle the engine longer. Should the fluid level below during this cold check, you must check the fluid hotbefore adding fluid. Checking the fluid hot will give you amore accurate reading of the fluid level.Checking the Fluid LevelPrepare the vehicle as follows:1. Park the vehicle on a level place. Keep the enginerunning.2. With the parking brake applied, place the shift leverin P (Park).3. With your foot on the brake pedal, move the shiftlever through each gear range, pausing for aboutthree seconds in each range. Then, positionthe shift lever in P (Park).4. Let the engine run at idle for three minutes or more.5-26

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.