X3の取扱説明書・マニュアル [全144ページ 4.54MB]
123812.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123812.pdf - 4.54MB
- キャッシュ
7902view
144page / 4.54MB
ReferenceAt a glanceControlsDriving tipsMobility 113For bulb replacement procedure, refer to Driver's side.Halogen high beamsH7 bulb, 55 wattsAlways wear gloves and eye protection - the atmosphere inside the H7 bulb is pressurized. Failure to observe this precaution can lead to injuries should the bulb be dam-aged.<For checking and adjusting headlamp aim, please contact your BMW Sports Activity Vehicle Center. <Driver's side1. Open the clip and remove the lamp cover.2. Press the bulb holder downward and remove, refer to Low beams.3. Pull off the lamp base; plug in a new lamp base.4. Place the lamp base with the lower edge against the bracket and press it in until the lamp base locks into place.Make sure that the cover does not fall into the engine compartment; otherwise, the vehicle can be damaged or other road users can be endangered. <Front passenger sideBefore replacing the bulb, remove the reservoir of the windshield washer system from the bracket, refer to Ha logen low beams on page 112 .For bulb replacement procedure, refer to Driver's side.Parking and roadside parking lampsW5W bulb, 5 wattsA bulb is located over each high beam.1. Remove bulb cover for high beams, refer to Halogen high beams.2. Remove bulb holder.3. Remove and replace the bulb.Turn signal, frontLamp PSY24W, 24 Watt or PSY24W Silver Vision*Access to the turn signal is at the edge of the lamp unit, refer to arrow.Make sure that the lamp base does not fall into the engine comp artment; otherwise, the vehicle can be damaged or other road users can be endangered. <1. Turn the lamp base and remove it.2. Replace the bulb.3. Insert the lamp base. If it does not snap into place immediately, turn the lamp base until it does.
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
53900 view
26344 view
21058 view
21213 view
23258 view
もっと見る