1. 取扱説明書・マニュアル >
2. BMW >
3. 自動車 >
4. X3 の使い方、故障・トラブル対処法 >
5. X3 の取扱説明書・マニュアル

X3の取扱説明書・マニュアル [全278ページ 10.85MB]

The LED flashes slowly.5. Release both buttons when the LED flashesrapidly.If the LED does not flash rapidly after approx.60 seconds, change the distance and repeatthe step.Canada: if the LED is not flashing rapidly af‐ter approx. 60 seconds, change the distanceand repeat the step, or, if the programmingwas interrupted by the hand-held transmit‐ter, hold down the memory button and pressand release the button on the hand-heldtransmitter again for 2 seconds.6. To program other hand-held transmitters,repeat steps 3 to 5.The device can be operated using the memorybutton with the engine running or the ignitionswitched on.MalfunctionIf the device cannot be used after repeated at‐tempts at programming, please check whetherthe hand-held transmitter is equipped with analternating code system.To do so:▷Read the instructions of the hand-heldtransmitter.▷Hold down the memory button of theintegrated universal remote control longer.If the LED of the integrated universal remotecontrol flashes rapidly for a brief period and thenlights up continuously, the hand-held transmit‐ter is equipped with an alternating code system.In this case, program the memory buttons asdescribed under Alternating-code hand-heldtransmitters.Alternating-code hand-heldtransmittersPlease obtain information on synchronizing thedevice in the operating manual of the device be‐ing set up.Programming will be easier with the aid of a sec‐ond person.1. Park the vehicle within range of the remote-controlled device.2. Program the integrated universal remotecontrol as described above under Fixed-code hand-held transmitters.3. Locate the button on the receiver of the de‐vice to be set, e.g., on the drive.4. Press the button on the receiver of the de‐vice to be set. You have approx. 30 secondsfor the next step.5. Hold down the programmed memory buttonof the integrated universal remote for ap‐prox. 3 seconds. Repeat this work step, ifnecessary, up to three times.The device can be operated using the memorybutton with the engine running or the ignitionswitched on.Reassigning individual programs1. Switch on the ignition.2. Hold the hand-held transmitter a distance ofapprox. 1 to 3 in/2.5 to 8 cm from the mem‐ory buttons.The required distance depends on themanual transmitter.3.Hold down the memory button of theintegrated universal remote control.4.If the LED flashes slowly after approx.20 seconds, press the transmit button onthe hand-held transmitter.5.Release both buttons when the LED flashesrapidly.If the LED does not flash rapidly after approx.60 seconds, change the distance and repeatthe step.Canada: if the LED is not flashing rapidly afterapprox. 60 seconds, change the distance andrepeat the step, or, if the programming was in‐terrupted by the hand-held transmitter, holddown the memory button and press and releaseSeite 117Interior equipment Controls117Online Edition for Part no. 01 40 2 608 153 - 09 11 490

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.