2
123146.pdf
hiyoko_kaijyu - 2013-08-21
http://153.127.246.254/.../123146.pdf - 0.30MB - キャッシュ
5606view
32page / 0.30MB
selected. The corresponding decimalpoint (11) must be lit.2Use sensor (4) to decrease the powerto level 0. The hotplate will automaticallyswitch off.To turn it off quickly: Whatever thepower level, the hotplate is turned offimmediately if you touch the and sensors (2/4) simultaneously.If all the cooking areas are positioned at 0,all the display points will flash.When a hotplate is switched off, an Hwillappear on the corresponding power dis -play if the surface of the glass in thecorresponding cooking area reaches atemperature at which there is a risk of bur -ning. When the temperature drops, thedisplay will go out (if the hob is disconnec -ted), or a 0is displayed if the hob is still on.SWITCHING THE APPLIANCE OFFThe appliance may be switched off at anytime by touching the general on / off sen -sor (1). When in standby mode, an Hisdisplayed on any hot areas. None of theother hotplate displays will light up.After use, disconnect the deviceusing the control; do not rely on thecookware detector.Locking the hob sensorsSAFETY FUNCTION (models ...635, ...645, ...735 AB and ...622)The safety function can be enabled afterthe hob is connected. To do so, touch sen -sor (1) to enable the touch control.Immediately, touch the sensor (4) andhold it down for five seconds. An L(for'Locked') will appear on the displays. Thetouch control will be switched off after afew seconds. If the cooking area is hot, anLand an Hwill appear alternately on thecorresponding display.This operation needs to be done within 10seconds, with no sensor other than thoseindicated being touched during that time,or the locking will not be carried out.The electronic control will remain lockeduntil the user unlocks it, even after the con -trol is disconnected using the sensor (1) or when restarting after there has beena power cut. Unlocking in order to cookTo unlock the control and use it, touch sen -sor (1) to enable the touch control.Immediately touch the two sensors onthe right at the same time. The Lvanishesfrom the displays and a 0appears with thelower point flashing, or an Hif the corres -ponding hotplate is hot, and the hob will beready to use for cooking. When you switchoff the control using the on/off sensor (1) the safety function will be re-enabledand will reappear the next time the touchcontrol is enabled.Cancelling the safety functionThe safety function can be permanentlydisabled by pressing sensor for 5seconds immediately after enabling thetouch control. This should be done within10 seconds after enabling the touch con -trol using the on/off sensor (1), and thesafety function will be cancelled. If this isnot done properly, the touch control willremain locked and will switch off after 20seconds.After cancelling the safety function, whenthe control is re-enabled using the on/offsensor (1), the hob will be ready to beGB17
