2
123146.pdf
hiyoko_kaijyu - 2013-08-21
http://153.127.246.254/.../123146.pdf - 0.30MB - キャッシュ
5606view
32page / 0.30MB
only be activated in another heating ele -ment on the right. Once this function has been activated in aheating element, the heating element onthe same side will only be able to workwith the power that is left over, up to a totalof 3,600/3,700 watts. If the power level istoo high, the touch control will automati -cally reduce it; this will be shown by theflashing of the indicator of the correspon -ding power (3).The Power function can be switched off inthe following ways:* By pressing the Power sensor or (6) again after selecting the cookingarea.* By touching the (4) key while the coo -king area is selected.The function may also disconnect automa -tically if the temperature in the cookingarea gets too hot. In all of these cases, thehotplate is kept running at power level 9. Ifthe pan is taken off the cooking area whilePower concentration is in operation, thefunction's remaining time will be stopped.If a pan is put back onto the cooking areabefore the pan detection time (10 minutes)has elapsed, the remaining time will startto count down again.The Power function can also be enabledwithout a pan on the cooking area, but thehotplate will not come on until the pan isput on the cooking area.The Power function takes priority over heat-up, so if the "Power" function is being used,heat-up will be cancelled in the inductioncooking areas on the corresponding side.Disconnection for safety purposesMAXIMUM OPERATING TIMEIf, due to absent-mindedness, one or morehotplates are left on, these will be switchedoff automatically after a set amount of timefrom the last action. (See table 3).After this "safety disconnection", thecorresponding hotplate's power displaywill show the Hif there is a risk of burning.Otherwise it will show the 0.SAFETY AGAINST COVERING SENSORSThe touch control has a feature that auto -matically disconnects the appliance whenit detects that something (a pan, cloth orspilled liquid) is covering the panel's sen -sors. This prevents the item from enablingor disabling a hotplate without you beingaware of it.When the touch control disconnects theappliance for safety reasons, it will beepuntil you remove the item that is coveringthe control panel.If the touch controls are on standby, itemsplaced over the hotplates will not be detec -ted; however, in order to enable the con -trol, any item covering it must be removed.Overheating safety featureThe induction areas are protected againstoverheating that may cause damage to theelectronic system. The induction generator has three mecha -nisms which become active if the tempera -ture rises too high in order to protect theelectronic components.GB27
