2
123146.pdf
hiyoko_kaijyu - 2013-08-21
http://153.127.246.254/.../123146.pdf - 0.30MB - キャッシュ
5606view
32page / 0.30MB
hot, its display will show an H, otherwise itwill show a 0. Touch any sensor to switchoff the beeping signal. Changing the programmed timeThe time that you have set can be chan -ged. To do so, touch the clock sensor (7) until the display of the correspondinghotplate (10) flash on.Then you will be able to read and changete time.Disconnecting the clockIf you wish to stop the clock before the pro -grammed time has elapsed:1Touch the clock sensor (7) so manytimes as it's needed, until the display ofthe corresponding hotplate (10) flashon, or just select the hotplate and touchthe clock sensor (7).2Make sure the decimal point is light (11)in the indicator (8). 3Use sensor (4) to reduce the timedown to 00. The clock is cancelled.Switching off quicklyRepeat the steps1 and 2.3Touching the and sensors (5 and4) at the same time cancels the remai -ning time.The clock as a countdown timerWhenever the clock is not being used inconjunction with a cooking area, it can beused as a countdown timer. SWITCHING THE COUNTDOWN TIMERONWhen the appliance is switched off.1Touch the timer button (7) as manytimes as necessary, until the correspon -ding countdown timer light (13), locatedin the centre, below the timer displays(8), turns on.2Make sure the decimal point is light (11)in the indicator (8). 3Use sensors and (4/5) to set thetime.After the set time has elapsed, a series ofbeeps will be emitted for several seconds.To turn off these beeps touch any of thebuttons, except the On/Off button (1).Adjusting the Programmed TimeTo adjust the programmed time, hold downthe timer button (7) until the countdowntimer light (13) flashes. You can then seethe time and adjust it.DISCONNECTING THE COUNTDOWNTIMERIf you wish to stop the countdown timerbefore the programmed time has elapsed:1Touch the timer button (7) as manytimes as necessary, until the correspon -ding countdown timer light (13) turns on,located centrally, below the timer dis -plays (8).2Make sure the decimal point is light (11)in the indicator (8). 3Use sensor (4) to reduce the time to00. The clock is cancelled.GB24
