1. 取扱説明書・マニュアル >
2. ボルボ >
3. 自動車 >
4. V50 の使い方、故障・トラブル対処法 >
5. V50 の取扱説明書・マニュアル

V50の取扱説明書・マニュアル [全322ページ 8.57MB]

06 Starting and drivingAlcolock* 06152* Option/accessory, for more information, see Introduction.Bypass function will then be possible, seepage 152 section Emergency situation.The message can be cleared by pressing thesend button (3) once. Otherwise it goes out onits own after approx. 2 minutes but then reap-pears each time the engine is started - onlyrecalibration at a workshop2 can clear the mes-sage permanently.Cold or hot weatherThe colder the weather the longer it takesbefore the Alcolock is ready for use:Temperature (ºC) Maximum heat-ing time (sec-onds)+10 to +85 10-5 to +10 60-40 to -5 180At temperatures below -20 ºC or above+60 ºC the Alcolock requires additional powersupply. The display shows ALCOGUARDINSERT POWER CABLE. In which case, con-nect the power supply cable from the gloveboxand wait until indicator lamp (6) is green.In extremely cold weather the heating time canbe reduced by taking the Alcolock indoors.Emergency situationIn the event of an emergency situation or theAlcolock is out of order, it is possible to bypassthe Alcolock in order to drive the car.NOTEAll Bypass activation is logged and saved inmemory, see page 10 in the section,Recording data.After the Bypass function has been activatedthe display shows ALCOGUARD BYPASSENABLED the whole time while driving andcan only be reset by a workshop2.The Bypass function can be tested without theerror message being logged - in which case,carry out all the steps without starting the car.The error message is cleared when the car islocked.When the Alcolock is installed, either theBypass or Emergency function is selected asthe bypassing option. This setting can bechanged afterwards at a workshop2.Activating the Bypass function•Depress and hold the left-hand stalkswitch READ button and the button forhazard warning flashers simultaneously forapprox. 5 seconds - the display first showsBYPASS ACTIVATED WAIT 1 MINUTEand then ALCOGUARD BYPASSENABLED - after which the engine can bestarted.This function can be activated several times.The error message shown during driving canonly be cleared at a workshop2.Activating the Emergency function•Depress and hold the left-hand stalkswitch READ button and the button forhazard warning flashers simultaneously forapprox. 5 seconds - the display showsALCOGUARD BYPASS ENABLED andthe engine can be started.This function can be used once, after which areset must be made at a workshop2.2An authorised Volvo workshop is recommended.

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.