11EnglishSwitching to a program type of yourchoice temporarily -------------------EON (Enhanced Other Networks) is another convenient RDSservice that allows this Unit to switch temporarily to a broadcastprogram of your choice (NEWS, TA or INFO) from the currentlyselected station, except if you are listening to a non-RDS station(all AM (MW/LW) stations or some FM stations).* The EON indicator lights up when tuned to a station whichprovides EON information.* If an FM station does not broadcast EON information, EONcannot be activated.1 Press the PTY/EON button on the RemoteControl twice while listening to an FMstation.The display alternates between "EON" and "SELECT."2 Select the program type with the 4 orc button on the Unit (or the UP orDOWN button on the Remote Control)within 10 seconds.The display shows a program type in the following order:TA:Traffic AnnouncementNEWS:NewsINFO:Programs on medical service, weather forecast, etc.OFF:Canceled3 Press the PTY/EON button on the RemoteControl again within 10 seconds to setthe selected program type.The selected program type indicator lights up on the display,and the Unit enters EON Standby mode.Case 1:If there is no station broadcasting the programtype you have selectedThe broadcast station being currently heard will continue to beheard.>When a station starts broadcasting the program you have selected,this Unit automatically switches to the station. The program type(TA, NEWS or INFO) indicator starts flashing.>When the program is over, this Unit goes back to the currentlyselected station, but still remains in EON Standby mode.Case 2:If there is a station broadcasting the programtype you have selectedThis Unit tunes to the station broadcasting the program. Theprogram type (TA, NEWS or INFO) indicator starts flashing.>When the program is over, this Unit goes back to the currentlyselected station, but still remains in EON Standby mode.Case 3:If the FM station you are listening to is broad-casting the program type you have selectedThe broadcast station being currently heard will continue to beheard. The program type (TA, NEWS or INFO) indicator startsflashing.>When the program is over, this Unit goes back to the currentlyselected station, but still remains in EON Standby mode.Notes:* If the EON is in standby mode and the source (CD, TAPE,AUX) is changed or the power is switched off, then the EONmode will be released. When the band is set to AM (MW/LW),the EON is not activated. When the band is set to FM again, theEON will be set to standby mode.* When the EON is being operated (i.e. the selected programtype is being received from the broadcast station) and if theDISPLAY MODE or 4, c button (or the </>/DOWN/UPbutton on the Remote Control) is operated, the station will notswitch back to the current selected station even after theprogram ends. The program type indicator remains in thedisplay, indicating that the EON is in standby mode.* When the EON is in standby mode and a radio broadcast isbeing recorded, be careful because the EON may be activatedand a different program than the intended one may be recorded.When the EON mode is not required, release the EON mode.* When the alarm signal is detected by EON, the stationbroadcasting the alarm is received with priority. "ALARM" isnot displayed.CAUTION:When the sound alternated intermittently be-tween the station tuned in by the EON functionand the current selected station, cancel the EONmode. This does not constitute malfunction ofthe Unit.(On the Unit)(On the Remote Control)orPTY/EONDOWN UPDOWNPTY/EONUPEN01-11.UX-V10/V20R[E] 00.1.20, 7:02 PM 11
参考になったと評価 11人が参考になったと評価しています。
関連サポート製品
Copyright © 2013 Gizport.jp All Rights Reserved.
