SAFFIRE LEの取扱説明書・マニュアル [全32ページ 1.17MB]
10
nManaging a recording session with SaffireControl LESaffireControl LE allows you to create independent latency free mixes of inputs and playback tracks for themonitors and headphones, so that the engineer and artist can have the specific levels they want to help thesession run smoothly. Be aware that if recording at 88.2/96kHz then the number of mix options is reduced,see the Changes to GUI at 88.2/96kHz section for details.nHow to set up an input mix on the monitors/headphonesThe six faders on the left of the GUI relate to Inputs 1-6 of the Saffire LE, 1-4 being the analogue Inputs and 5 + 6 being the S/PDIF Input on the rear panel. The faders on top are the mix of Inputs for the Monitors(Outputs 1/2aders below are the mix for the Headphones (Outputs 3/4If using stereo signals, activate the stereo button for the corresponding Inputs (located in between the panpots for each pair of faders), which links the level of both and sets the pan pots to L and R. Now use thefaders to set specific levels of each Input.If you are not hearing any of the Inputs on the Monitors or Headphones then make sure that thecorresponding INPUT MIX-P/BACK MIX slider isn't in the extreme right position, where no Inputs are heard.Read the Blending between inputs and playback tracks on the monitors/headphones section for details.nHow to set up a playback track mix on the monitors/headphonesThe right hand side of the SaffireControl LE GUI has two sets of four (stereo) faders, each set representingthe levels of Outputs 1-8 from the sequencer/recording platform. For example, any stereo track within thesequencer that's routed to Saffire Outputs 5/6 will appear on the third fader from the left (S/W 5/6set - it won't go directly from the sequencer to the Saffire LE hardware Outputs unless the S/CARD switch is activated or SaffireControl is correctly set up. This way, the pre-recorded audio (playback tracks) can beblended with the inputs t ocreate latency free mixes whilst recording. The set of faders on top are the playback mix for the Monitors (O/Ps 1/2) and the faders below are theplayback mix for the Headphones (O/Ps 3/4). When recording, route the drums, melodies and other backingtracks to different Saffire Outputs within the sequencer so the specific levels for the Monitors/Headphonescan be set accordinglyhere.
