SAFFIRE LEの取扱説明書・マニュアル [全32ページ 1.17MB]
10
nTroubleshooting (continued)Nosignal heard on the Monitors¥ Is the level of the Monitors turned up within SaffireControl LE and the Mute switch inactive?¥Is the MONITOR dial on the hardware set sufficiently high.¥ Are the mix controls (Input Mix faders, S/W (Playbackaders and INPUT MIX-P/BACK MIX slider) set correctly? If you are attempting to play back tracks from the sequencer and the slider is in the extreme left position (just INPUT MIX) then no Playback Tracks will be heard.NoPlayback tracks heard on Monitors/Headphones¥ Is the INPUT MIX-P/BACK MIX slider for the Monitors/Headphones set far enough to the right, towards the P/BACK MIX end? If not, only the INPUT MIX will be heard.¥ Do the tracks within the sequencer have sufficient level? The level set by the faders on the right of the SaffireControl LE window are respective to that set within the sequencer.¥ Are the S/W faders that audio is routed to in the sequencer set correctly in SaffireControl LE? If you have routed all tracks to Saffire LE Outputs 5/6 and 7/8 and S/W faders 5/6 and 7/8 are down for the monitoring outputs, no signal will be heard.Cannot set a sample rate¥ Is Saffire LE being used to record audio? Whilst audio is being recorded, IN USE will show and the sample rate cannot be selected.Cannot lock to an external device¥ Is a valid S/PDIF source connected to the S/PDIF Input on the rear panel?¥Is SaffireLE set tothe same samplerate as the digital audio received at the S/PDIF In? If not, a Lock cannot be achieved.¥ Are you using a Mac rather than a PC? You could be experiencing a core audio driver problem. Check the Applewebsitefor coreaudio driver updates or consult the Focusrite online answerbase.The Compressor is not working¥Is the plug-in active? The small switch on the left of the plug-in windo wmustbe illuminated.¥Are the compressor controls set correctly? The threshold must be low enough for the signal to exceed it for the compressor to have any effect. The EQ is not working¥ Is the plug-in active? The small switch on the left of the plug-in window must be illuminated.¥Arethe EQ controls in a position tohavean effect on frequencies that are present in the signal? For example, a low-pass filter working on the upper frequencies will have little effect on a bass part. The Reverb is not working¥ Is the AMOUNT dial set sufficiently high? If not, no reverb will be added.¥ Is the TONE control set to an extreme position in the plug-in window?For more technical support, visit the online ANSWERBASE @ www.focusrite.com
