SAFFIRE LEの取扱説明書・マニュアル [全32ページ 1.17MB]
10
nRecording a guitar or bass directlyAll four of the analogue inputs can be used to record an Instrument, such as a Guitar or Bass plugged indirectly without using an amp. To record using Input 1 or 2, plug a 1/4" TS Jack into either of the LINE IN sockets on the front panel, left forInput 1 and right for Input 2. This will automatically bypass any microphones that may be connected to theXLR Inputs below. Now make sure that the yellow INST LED is illuminated in the corresponding section atthe top of the front panel.Now play the Instrument and set the level of the input using the gain adjustment knob on the front panel.Rotate the dial clockwise to increase the level, making sure that the O/L LED on the hardware neverilluminates as this indicates that the level is exceeding the maximum level of the digital converter (clippingpoint). For an even easier indication of level, observe the level of the meter below Input 1 or 2 on the left ofthe SaffireControl LE software GUI, as shown:This signal will nowappear as SaffireLE Input 1 or Input 2 (depending on which sock et the Instrument isconnected to) within your sequencer/recording application. If recording using Input 3 or 4, plug a 1/4" TS Jack into either of the sockets in the top left of the hardwareÕsrear panel, below for Input 3 and above for Input 4. Now, activate the High Gain switch for that Input in theSaffireControl LE softwareÕs GUI, as follows:Nowplay the Instrument and observe the O/L LEDs for Inputs 3 and 4 on the front of the hardware. If they are illuminating, turn down the level on the Instrument.This signal will now appear as Saffire LE Input 3 or Input 4 (depending on which socket the Instrument is connected to) within your sequencer/recording application. Level of Input 1(Recorded level)Level of Input 2(Recorded level)High Gain Switch for Input 4 - engage if an Instrument is connectedHigh Gain Switch for Input 3 - engage if an Instrument is connected
