OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]
optiplex-g1_User%27s%20Guide_en-us.pdf
ftp://ftp.dell.com/.../optiplex-g1_User%27s%20Guide_en-us.pdf - 1.59MB
- キャッシュ
22573view
174page / 1.59MB
Inside Your Computer: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/inside.htm [2/21/2013 11:47:19 AM]cage3Tab4Hook4. Slide the expansion-card cage out of the chassis.5. Lift the expansion-card cage up and away from the chassis.To replace the expansion-card cage in the small-form-factor chassis, perform the following steps:1. With the securing lever in the upright position, align the slots in the left side of the expansion-card cagewith the tabs on the back and bottom of the chassis (see Figure 5). Slide the expansion-card cage intoplace. 2. Rotate the securing lever downward until it is flush with the top side of the chassis. Make sure that theriser board is fully seated in the RISER connector on the system board.3. Reconnect any cables you removed in step 2 of the previous procedure.4. Replace the computer cover, and reconnect your computer and peripherals to their electrical outletsand turn them on.NOTE: If Enabled, the Chassis Intrusion option will cause the following message to be displayedat the next system start-up:ALERT! Cover was previously removed.Back to Contents Page
参考になったと評価
2人が参考になったと評価しています。
その他の取扱説明書
249 view
189 view
258 view