1. 取扱説明書・マニュアル >
2. DELL >
3. パソコン >
4. パソコン本体 >
5. デスクトップパソコン >
6. OptiPlex G1 の使い方、故障・トラブル対処法 >
7. OptiPlex G1 の取扱説明書・マニュアル

OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]

Setup and Operation: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/setup.htm [2/21/2013 11:47:10 AM]Existing System Password "). If you assign and later forget a system password, you must remove thecomputer cover to change a jumper setting that disables the system password feature (see " Disabling aForgotten Password "). Note that you erase the setup password at the same time.NOTICE: If you leave your system running and unattended without having a system passwordassigned, or if you leave your computer unlocked so that someone can disable the password bychanging a jumper setting, anyone can access the data stored on your hard-disk drive.Assigning a System PasswordBefore you can assign a system password, you must enter the System Setup program and check theSystem Password option.When a system password is assigned, the setting shown in System Password is Enabled. When thesystem password feature is disabled by a jumper setting on the system board, the setting shown is Disabledby Jumper. You cannot change or enter a new system password if either of these options is displayed.When no system password is assigned and the password jumper on the system board is in the Enabledposition (its default), the option shown for the System Password option is Not Enabled. Only when SystemPassword is set to Not Enabled can you assign a system password , using the following procedure:1. Verify that Password Status is set to Unlocked.2. Highlight System Password, and then press the left- or right-arrow key.The option heading changes to Enter Password, followed by an empty 32-character field in squarebrackets.3. Type your new system password.You can use up to 32 characters in your password.As you press each character key (or the spacebar for a blank space), a placeholder appears inthe field. The password assignment operation recognizes keys by their location on the keyboard,without distinguishing between lowercase and uppercase characters. For example, if you have anM in your password, the system recognizes either M or m as correct.Certain key combinations are not valid. If you enter one of these combinations, the speaker emitsa beep.To erase a character when entering your password, press the <Backspace> key or the left-arrowkey.NOTE: To escape from the field without assigning a system password, press the <Tab>key or the <Shift><Tab> key combination to move to another field, or press the <Esc> keyat any time prior to completing step 5.4. Press <Enter>.If the new system password is less than 32 characters, the whole field fills with placeholders.Then the option heading changes to Verify Password , followed by another empty 32-characterfield in square brackets.

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.