1. 取扱説明書・マニュアル >
2. DELL >
3. パソコン >
4. パソコン本体 >
5. デスクトップパソコン >
6. OptiPlex G1 の使い方、故障・トラブル対処法 >
7. OptiPlex G1 の取扱説明書・マニュアル

OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]

System Setup Options: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/setupopt.htm [2/21/2013 11:47:16 AM]Date resets the date on the computer's internal calendar.Your system automatically displays the day of the week corresponding to the settings in the three fields thatfollow (month, day-of-month, and year).To change the date, press the right-arrow key to increase the number in the highlighted field or press theleft-arrow key to decrease the number. If you prefer, you can type numbers in the month and day-of-monthfields.Diskette Drive A, Diskette Drive B, and Use ZIP as A or BDiskette Drive A and Diskette Drive B identify the type of diskette drives installed in your computer. Withthe standard cabling configuration, Diskette Drive A (the boot diskette drive) is the 3.5-inch diskette driveinstalled in the top externally accessible drive bay; Diskette Drive B is any drive installed in the bottomexternally accessible drive bay that is connected to the system's diskette/tape drive interface.The option settings always match the physical locations of the drives in your computer-the first drive listedon Page 1 of the System Setup screens is the top drive in your computer.The options are:5.25 Inch, 360 KB5.25 Inch, 1.2 MB3.5 Inch, 720 KB3.5 Inch, 1.44 MBNot InstalledUse ZIP as A or B is used to control the operation of an internally installed Advanced TechnologyAttachment Packet Interface (ATAPI) Zip drive. The options are On and Off. When set to On, the Zip driveoperates as a diskette drive and can be booted. When set to Off , the Zip drive operates as a normal ATAPIdevice.You can have a total of two diskette devices, either diskette drives or Zip drives.NOTE: Tape drives are not reflected in the Diskette Drive A and Diskette Drive B options. Forexample, if you have a single diskette drive and a tape drive attached to the diskette/tape driveinterface cable, set the Diskette Drive A option to match the characteristics of the diskette drive andset the Diskette Drive B option to Not Installed.Drives: Primary and SecondaryPrimary identifies drives attached to the primary enhanced integrated drive electronics (EIDE) interfaceconnector (labeled "IDE1") on the system board; Secondary identifies drives connected to the secondaryEIDE interface connector (labeled "IDE2"). Dell recommends that you use the secondary EIDE interfaceconnector for EIDE CD-ROM and EIDE tape drives.

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.