OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]
optiplex-g1_User%27s%20Guide_en-us.pdf
ftp://ftp.dell.com/.../optiplex-g1_User%27s%20Guide_en-us.pdf - 1.59MB
- キャッシュ
22236view
174page / 1.59MB
System Setup Options: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/setupopt.htm [2/21/2013 11:47:16 AM]periods (see Table 3) for the two successive monitor shutdown stages, standby and off.NOTE: Each monitor manufacturer defines the details of the shutdown stages for its own monitors.But in all cases, power consumption decreases with each stage from "on" (full power) to "standby"(reduced power; the display image usually disappears) to "off" (where power consumption is minimal).To define these stages for your monitor, see the documentation that came with the monitor.From either shutdown stage, you can return full power to the monitor in one of the following ways:For most DPMS-compliant monitors, any subsequent activity-including moving the mouse-shouldreturn full power to the monitor.A few DPMS-compliant monitors require that you turn monitor power off and then on again to return tofull power.Check your monitor documentation for information on how your monitor is designed to operate.Saving EIDE Hard-Disk Drive PowerFor most systems, enabling Power Management at any level causes EIDE hard-disk drives to switch to low-power mode after about 20 minutes of system inactivity (see Table 3).NOTES: All EIDE drives shipped with your system support this feature. (For more information, see"ENERGY STAR(R) Compliance .")However, not all EIDE hard-disk drives support this feature. Enabling this feature for drives that do notsupport it may cause the EIDE drive to become inoperable until the computer is restarted and thePower Management option is disabled.In low-power mode, the disks inside the drive stop spinning. They remain idle until the next drive access,which causes them to start spinning again. (Because the disks take a few seconds to regain full speed, youmay notice a slight delay when you next access the hard-disk drive.)When Power Management is set to Disabled (the default), the disks spin constantly as long as the systemis turned on.Table 3. Power Time-Out PeriodsPowerManagement SettingEIDE Drive SpindownTime-OutsMonitor StandbyTime-OutsMonitor OffTime-OutsDisabled Never Never NeverMaximum 20 minutes 10 minutes 1 hourRegular 20 minutes 20 minutes 1 hourMinimum 20 minutes 1 hour Never
参考になったと評価
2人が参考になったと評価しています。
その他の取扱説明書
237 view
184 view
252 view