OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]
optiplex-g1_User%27s%20Guide_en-us.pdf
ftp://ftp.dell.com/.../optiplex-g1_User%27s%20Guide_en-us.pdf - 1.59MB
- キャッシュ
21742view
174page / 1.59MB
Dell Diagnostics: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/diag.htm [2/21/2013 11:47:14 AM]Starting the Dell DiagnosticsPerform the following steps to start the diagnostics:1. Turn on the system.2. Enter the System Setup program by restarting the computer and pressing <F2> when prompted.3. Confirm that all ports are enabled. Also, make sure that the Boot Sequence option is set to DisketteFirst.4. Place your Dell Diagnostics diskette in the diskette drive, and press <Alt><b> to restart the system.5. At the MS-DOS(R) prompt, type delldiag and press <Enter>.NOTE: Before you read the rest of this section, you may want to start the Dell Diagnostics so that youcan see it on the screen of your monitor.When you start the diagnostics, the Dell logo screen appears, followed by a message telling you that thediagnostics is loading.After the diagnostics loads, the Diagnostics Menu appears (see Figure 1). The menu allows you to run allor specific diagnostic tests or to exit to the MS-DOS prompt.For a quick check of your system, select the Run Quick Tests option. This option runs only the subtests thatdo not require user interaction and that do not take a long time to run. Dell recommends that you choose thisoption first to increase the odds of tracing the source of the problem quickly. For a thorough check of yoursystem, select the Run All Tests option. To check a particular area of your system, select the Run SpecificTests option.To select an option from this menu, highlight the option and press <Enter>, or press the key that correspondsto the highlighted letter in the option you choose.Figure 1. Diagnostics Menu
参考になったと評価
2人が参考になったと評価しています。
その他の取扱説明書
230 view
178 view
247 view