1. 取扱説明書・マニュアル >
2. DELL >
3. パソコン >
4. パソコン本体 >
5. デスクトップパソコン >
6. OptiPlex G1 の使い方、故障・トラブル対処法 >
7. OptiPlex G1 の取扱説明書・マニュアル

OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]

Battery: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/battery.htm [2/21/2013 11:47:21 AM]Back to Contents PageBattery: DellTM OptiPlexTM GX1 Small-Form-Factor System User'sGuideOverview Replacing the BatteryOverviewA 3.0-volt (V) CR2032 coin-cell battery installed on the system board maintains system configuration, date,and time information in a special section of memory.The operating life of the battery can extend up to ten years. The battery may need replacing if an incorrecttime or date is displayed during the boot routine along with a message such as:Time-of-day not set - please run SETUP programorInvalid configuration information - please run SETUP programorStrike the F1 key to continue,F2 to run the setup utilityTo determine whether you need to replace the battery, reenter the time and date through the System Setupprogram and exit the program properly to save the information. Turn off your system and disconnect it fromthe electrical outlet for a few hours; then reconnect and turn on your system. Enter the System Setupprogram. If the date and time are not correct in the System Setup program, replace your battery.You can operate your system without a battery; however, without a battery, the system configurationinformation is erased if the system is turned off or unplugged from the electrical outlet. In this case, you mustenter the System Setup program and reset the configuration options.CAUTION: There is a danger of the new battery exploding if it is incorrectly installed. Replacethe battery only with the same or equivalent type recommended by the manufacturer. Discardused batteries according to the manufacturer's instructions.Replacing the BatteryTo replace the system battery, perform the following steps: 1. If you have not already done so, make a copy of your system configuration information in the SystemSetup program.If the settings are lost while you are replacing the battery, refer to your written or printed copy of thesystem configuration information to restore the correct settings. See " Using the System Setup

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.