1. 取扱説明書・マニュアル >
2. DELL >
3. パソコン >
4. パソコン本体 >
5. デスクトップパソコン >
6. OptiPlex G1 の使い方、故障・トラブル対処法 >
7. OptiPlex G1 の取扱説明書・マニュアル

OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]

Hard-Disk Drives: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/harddisk.htm [2/21/2013 11:47:23 AM]Back to Contents PageHard-Disk Drives: DellTM OptiPlexTM GX1 Small-Form-FactorSystem User's GuideGeneral Information About EIDE Hard-DiskDrivesInstalling an EIDE Hard-Disk Drive in a Small-Form-Factor ChassisGeneral Information About EIDE Hard-Disk DrivesThe small-form-factor chassis supports a single enhanced integrated drive electronics (EIDE) hard-disk drivein the hard-disk drive bay.EIDE Drive AddressingYou must configure all EIDE devices for the Cable Select jumper position, which assigns master and slavestatus to devices by their position on the interface cable. When you connect two EIDE devices to a singleEIDE interface cable and configure them for the Cable Select jumper position, the device attached to the lastconnector on the interface cable is the master or boot device (drive 0), and the device attached to the middleconnector on the interface cable is the slave device (drive 1). Refer to the drive documentation in yourupgrade kit for information on setting devices to the Cable Select jumper position.With the two EIDE interface connectors on the system board, your system supports up to four EIDE devicesin the mini tower chassis; the small-form-factor and low profile chassis support up to two EIDE devices.EIDE hard-disk drives should be connected to the EIDE interface connector labeled "IDE1." (Always connectEIDE tape drives and CD-ROM drives to the EIDE interface connector labeled "IDE2.")Installing an EIDE Hard-Disk Drive in a Small-Form-Factor ChassisTo install an EIDE hard-disk drive in a small-form-factor chassis, perform the following steps.CAUTION: To avoid the possibility of electric shock, turn off the computer and any peripherals,disconnect them from electrical outlets, and then wait at least 5 seconds before you removethe computer cover. Also, before removing the computer cover, see the other precautions in"Safety First-For You and Your Computer."1. If you are replacing a hard-disk drive that contains data you want to keep, be sure to make a backup ofyour files before you continue this procedure.2. Prepare the drive for installation.NOTICE: Ground yourself by touching an unpainted metal surface on the back of the computer.NOTICE: When you unpack the drive, do not set it on a hard surface, which may damage thedrive. Instead, set the drive on a surface, such as a foam pad, that will sufficiently cushion it.Check the documentation for the drive to verify that it is configured for your computer system.

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.