OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]
optiplex-g1_User%27s%20Guide_en-us.pdf
ftp://ftp.dell.com/.../optiplex-g1_User%27s%20Guide_en-us.pdf - 1.59MB
- キャッシュ
21721view
174page / 1.59MB
Setup and Operation: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/setup.htm [2/21/2013 11:47:10 AM]The power indicator in the center of the power button lights up when the computer is receiving power. Usethe power indicator to help you identify a system problem if the system does not boot when you press thepower button to turn on the computer.CAUTION: Before you remove DIMMs, see " Safety First-For You and Your Computer ."A solid green power indicator and a beep code during power-on self-test (POST) indicate that a dual in-line memory module (DIMM) may be faulty or is not properly seated. Remove all DIMMs, install onlyone DIMM, and then reboot. Repeat this procedure until you identify the faulty or improperly seatedDIMM.A solid green power indicator and no beep code and no video during POST indicate that the monitor orthe integrated video controller may be faulty. See " Troubleshooting the Monitor." If the monitor isoperating properly and is correctly connected, see " Getting Help" for instructions on getting technicalassistance from Dell.A solid green power indicator and no beep code with video during POST indicate that an integratedsystem board device may be faulty. See " Getting Help" for instructions on getting technical assistancefrom Dell.Power ButtonThe power button controls the system's AC input power.The Microsoft(R) Windows(R) 98 and Windows 98 Second Edition (SE) operating systems let you configure thefunction of the power button through the Advanced Configuration and Power Interface (ACPI) feature (seeTable 1).NOTICE: To turn off your computer system, perform an orderly system shutdown using the operatingsystem menu when possible.Table 1. Power Button Behavior Under Microsoft Windows 98 and Windows 98 SE Operating SystemsWith ACPIAction ResultsSystem Turned On and ACPI EnabledSystem in StandbyModeSystem Turned OffPress power button System goes intostandby mode or turnsoff (depending on theoperating system setup)System turns on Boots and system turnsonHold power button for 6 seconds*System turns offimmediatelySystem turns offimmediatelyBoots and system turnson* Pressing or holding the power button to shut down the system may result in data loss. Use the powerbutton to shut down the system only if the operating system is not responding.Microsoft Windows 95 does not support ACPI. Table 2 shows power button functions for Windows 95operating systems and for Windows 98 operating systems that have the ACPI feature disabled.
参考になったと評価
2人が参考になったと評価しています。
その他の取扱説明書
230 view
178 view
247 view