OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]
optiplex-g1_User%27s%20Guide_en-us.pdf
ftp://ftp.dell.com/.../optiplex-g1_User%27s%20Guide_en-us.pdf - 1.59MB
- キャッシュ
21721view
174page / 1.59MB
Dell Diagnostics: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/diag.htm [2/21/2013 11:47:14 AM]the previous subsection, " Output Device for Status Messages ."After running particular diagnostic tests and viewing the error messages generated by the tests in theresult file, you can erase the contents of the file so that it is clear for the next set of messagesgenerated. Otherwise, the next messages are added at the end of the previous ones in the file.Test LimitsNOTE: The Dell Diagnostics sets default limits on all tests. The only reason to change the defaultwould be to limit the amount of testing done.The RAM Test Group, the Video Test Group , the Diskette Drives Test Group , the IDE (ATA/ATAPI)Devices Test Group , the Serial/Infrared Ports Test Group , the Parallel Ports Test Group , and the SCSIDevices Test Group allow you to designate limits. Whether you select Test Limits for a highlighted testgroup (from the Main menu) or a subtest (from the Subtest menu), you set the limits for all the subtests inthat test group. When you select Test Limits , a new screen appears and the Key-Help area lists keys to usewith the new screen. Press <Page Down> to select the next menu or submenu. Press <Esc> to return to themain Test Limits window.How you change a value for the limits of a test group or subtest depends on the type of parameterassociated with it. Different keys are used to change values for different types of parameters. For example,memory address limits specified for the RAM Test Group are changed by typing in numbers over the digitsof a given limit or by pressing the plus (+) or minus (-) keys to increase or decrease the given limit. Incontrast, to set limits for the Serial/Infrared Ports Test Group, you use the spacebar to toggle between Yesand No.After you are satisfied with the limits, return to the Dell Diagnostics main screen by pressing <Esc>. Thevalues you selected under Test Limits remain in effect during all the test groups or subtests you run, unlessyou change them. However, the values are reset to their defaults when you restart the diagnostics.AboutAbout in the Main menu lists all of the subtests for the selected test group and displays information aboutthe subtest that is highlighted.Key-HelpKey-Help always displays a list of key controls available for the particular category you have selected.QuitSelecting Quit from the Main menu exits the diagnostics and returns you to your operating systemenvironment.After you return to the operating system environment, remove your diagnostics diskette from drive A andreboot the computer.NOTICE: It is important that you quit the diagnostics correctly because the program writes data to thecomputer's memory that can cause problems unless properly cleared.
参考になったと評価
2人が参考になったと評価しています。
その他の取扱説明書
230 view
178 view
247 view