1. 取扱説明書・マニュアル >
2. DELL >
3. パソコン >
4. パソコン本体 >
5. デスクトップパソコン >
6. OptiPlex G1 の使い方、故障・トラブル対処法 >
7. OptiPlex G1 の取扱説明書・マニュアル

OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]

System Setup Options: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/setupopt.htm [2/21/2013 11:47:16 AM]After you verify the password, the Setup Password setting changes to Enabled . The next timeyou enter the System Setup program, the system will prompt you for the setup password.A change to the Setup Password option becomes effective immediately (rebooting the system isnot required).Operating With a Setup Password EnabledIf Setup Password is set to Enabled, you must enter the correct setup password before you can modify themajority of the System Setup options.When you start the System Setup program, Page 2 of the System Setup screens appears with the SetupPassword option highlighted, prompting you to type the password.If you do not enter the correct password in three tries, the system lets you view, but not modify, the SystemSetup screens-with the following exceptions:If System Password is not enabled and is not locked via the Password Status option, you canassign a system password (however, you cannot disable or change an existing systempassword).NOTE: You can use the Password Status option in conjunction with Setup Password toprotect the system password from unauthorized changes.Deleting or Changing an Existing Setup PasswordTo delete or change an existing setup password, perform the following steps:1. Enter the System Setup program and go to Page 2 of the System Setup screens.2. Highlight the Setup Password option, type in the setup password, and press the left- or right-arrowkey to delete the existing setup password.The setting changes to Not Enabled.3. If you want to assign a new setup password, follow the procedure in "Assigning a Setup Password ."Disabling a Forgotten PasswordIf you forget your system or setup password, you cannot operate your system or change settings in theSystem Setup program until you remove the computer cover, change the password jumper setting to disablethe passwords, and erase the existing passwords.To disable a forgotten password, perform the following steps.CAUTION: To avoid the possibility of electric shock, turn off the computer and any peripherals,disconnect them from electrical outlets, and then wait at least 5 seconds before you removethe computer cover. Also, before removing the computer cover, see the other precautions in"Safety First-For You and Your Computer ."

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.